My Screen will not come out any more i have had my cable upgrade a few months ago and now when i push the button i get nothing the screen will not come out at all it just stopped working all of the sudden.
An expert who has achieved level 2 by getting 100 points
An expert that got 5 achievements.
An expert who has answered 200 questions.
An expert whose answer got voted for 20 times.
Re: Avic-n2 Screen Movement
The new ribbon cables had also found to be defected and failed some within 3 months, the best ribbon cables are sold by that guy on ebay. His ribbon cables meet military spec. I have no affiliate with him but good service will get you good reputation.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Those blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section inside it. This will make repair easy. These are called blinking codes. Make sure about the exact number of blinking of the standby/power LED, by switching On & OFF the set, for at least two times. Count it carefully. If you wish to get some details, check the site linked here. It has details about blinking codes, and fault locating procedure, to many popular brand TVs and other devices. http://homenol.blogspot.com/ http://electronicshelponline.blogspot.com/
If blinks continue without any pause, the main board is faulty.
These blinks (flashes) are fault indication. By the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit stage inside the TV. Count the blinks occur at one time switch ON, carefully. Do it once again, and make sure about the number of blinks. If the flashes are continious, non-stop, the main system control IC should be suspected. If you wish to get more details, check the site linked here. It has blinking codes detail to many brand TVs. Pull up older posts. Check the site in 'Mosaic' view. It will make search easy. http://electronicshelponline.blogspot.com/
Sounds like someone shorted the wires...you need to look into the entire butcher job and see what wires were touched. Disconnect everything the butcher did and then see if your battery is still drainning power.
Hello, Thank You for using FixYa. I will be helping you today.Sounds like your door switch failed.Thats the reason it would not stop a few months ago.Its part # 3406105
Thank You and please rate my answer if it was helpful..
Ive seen this on other monitors. Look for a 1 and 2. Some monitors do NOT auto detect a signal, and this one might not. Look for a way to set the monitor from Digital input to VGA input. Try that and see.
I have seen Pioneer replaced ribbon cables fail in as little as 3 months. Rick on Ebay guarantee his cables for life or as long as you own it. His company name is Same Day Audio Services and he is very reliable. He will do it for around $100. Pioneer only replace it free for the first time, after that they might charge up to $220. Good luck.
PS. I fix service and sell the Avic N series on Ebay.I get my part from Rick, mention Hogan from Utah and you might get a discount.
I had the same problem, and finally figured out to reset it. The reset button is on the left side under the strip. You need a pen to push it in. It took a few seconds to reboot but it came on normal after that.