Question about Dewalt DC920KA Heavy Duty Xrp 18V Cordless Drill/Driver
Posted by Anonymous on
SOURCE: chuck will not release bit
the Chuck should be 2 Part.
Use 2 pair of stillsons Or pipe wrenches, Tight On the 2 Chuck Parts, Crack in opposite Directions.
Alternative, Use Wrench On Chuck Jaw, Short sharp Blow With Hammer.
Mike @ compurepair.
Posted on Feb 28, 2008
If you find that the end of the screw inside the chuck is actually broke then you have a gear problem inside your drill. This is actually a very common problem. Sometimes people push too hard on their drills and the gears inside wear out and break. This prevent the motor from wearing out, but, the gears have to be replaced.
If it is the gears and not the chuck. you broke the minimium of the front gear or gears inside your drill. YOU CANNNOT repair gears. they need to be replaced. you may be able to find some off brand gears to work but, you run the risk that they are not as strong as your original ones, or may not be exactly grooved correctly.
so, if replacing your chuck does not work. find replacement gears. IF you cannot find the gears from the manufacturer see about replacing your drill.
If the chuck is still good, keep it. If you buy the same model, keep your old drill for replacement parts, ie, switch, armature, cord, etc.
hope this helps somewhat.
Posted on Jun 11, 2009
I simply placed the chuck into a large vise and turned the drill counter clockwise and the chuck spun right off no problem without damaging anything!! It does have some thread lock on the chuck but just use your man strength and its as simple as turning the lid off the pickle jar! Do not waste your time or money with the removal tool...YOU DONT NEED IT!
Posted on Oct 18, 2009
Open the chuck as wide as it will go and then remove the machine screw from it,it's down inside the chuck.Now,put a 5/16 allen wrench in the chuck and tighten it.Hold the drill with the chuck away from you and hit the allen wrench with a hammer,with the wrench to your right and making the hit drive it downward.Spin it off with your fingers from here,hope this helps.
Posted on Jan 29, 2010
SOURCE: how to remove the chuck?
open the chuck fully and it shoudl have a screw inside. Unscrew it, but be carefull, these screws are usually reversed - to uncsrew, rotate it clockwise. Once done, put allen key into chuck (short side in), fasten the chuck to hold allen key well and hit the key with hammer - counterclockwise direction. You might want to verify this procedure with someone else as I have no experience with Dewalt, but this way it works for Makita, Metabo, Narex, ... then why not for Dewalt? Juraj
Posted on Jun 08, 2010
Tips for a great answer:
Oct 07, 2017 | Hitachi Drills
Feb 07, 2015 | Bosch 13618 - 2G 18V Brute Tough Cordless...
Dec 01, 2013 | Drills
Apr 16, 2011 | Drills
Mar 10, 2011 | Dewalt 18 Volt Compact Drill Kit
Apr 04, 2010 | Dewalt 3/8" Electric Drill D21009
Mar 29, 2010 | Makita 12 Volt Cordless Drill/Driver Kit
Oct 07, 2009 | Dewalt DC988VA XRP 3 - speed 1/2" 18v...
May 19, 2009 | Black & Decker Drills
50 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: