Foxconn 865g7 reset switch - Foxconn 865G7MF-SH Motherboard

http://www.pcityourself.com/building/frontPanelConnections.php


HERE HOW IT IS MADE IN GENERAL.

Download the Foxconn 6627MA-RS2H manual here.
Yoiu can find the layout od the FP1 connector at Chapter 2 Installation Instructions page 13.

I think you check 1st Power Supply working or not .

HI,

It could be a Foxconn or a Winfast board. Those are the only two companies that used that number.

Good Luck

Mark

Hi.
Yes you can, the board has an AGPx8 slot.






Please rate this solution if it was helpful. Thanks

there is a label on the mothereboard on what connector you will put..youll see hdd,pwr something like that

yeh, the power and reset has two side by side button switches on the mobo itself. small squares with small round buttons that click when pressed !

On the Foxconn boards all connectors are the standard model, always with the name of the connector printed on the board. In your case probably the speaker has a wide connector - 3 pins wide instead of 2.  Just pair the matching names.
Here are some generic instruction - http://www.pcguide.com/byop/byop_OtherCaseConnectorsandSwitches.htm

If your board is the one in this manual, the pins are located very close to the CMOS battery. Page 21 in that manual shows the diagram. Power LED is the top two left pins. Hard disc LED is the bottom two left pins. Power switch is the top two right pins. Reset switch is pins 3-4 on the bottom row. Pin 5 on the bottom is not used.

if you can connect to internet, go here. It is well worth the price.