Does a Kenwood KRC 278 R have RCA inputs?

Just run an cable (3.5mm headphone jack into stereo rca cable) from your ipod's earphone jack to one of the available input channels on your amplifier. I put mine into the front auxiliary input on my amp and just simply selected that channel on the amp. Hope it helps. By the way, an RCA cable is the one with the white and red plugs.

Hi,yes you can connect Kenwood KR-4600 to an ipod.


Instruction..

You will need an RCA cable .


Connect the RCA (red and black to the input of the Kenwood KR-4600...You have options of inputs to use..

Either input at the back of the Kenwood KR-4600,or tape A and tape B..which ever you wan to use..

After connecting the red and black RCA to Kenwood KR-4600, then connect the other jack end to the ipod, and go the front of the Kenwood KR-4600 to activate the input selection knob to the desired input being selected at the back of the Kenwood KR-4600..

And don't forget to turn on the volume of the Kenwood KR-4600 and also the iPod volume..

And after that your done..

Good luck to you..

here is

http://www.kenwood.ca/Support/Car_Files/#_

KRC 260 and 280 are close to yours just select them in this link and download owners guide/

Try disconnecting input power for an hour or so....this sometimes will send a unit into manual reset mode.

I’m happy to assist further over the phone at https://www.6ya.com/expert/robert_aad3edb7dfa380b9

Here is the owners manual:

"http://www.payloadz.com/go/sip?id=889718"

Get a cassette to ipod hook up. They are just black cassette tapes with a cord coming out that plugs into your ipods earphone jack. They're usually around $20.00

no sorry cant help

According to the manual, the AUX input is an optional accessory.

Check to see if the RCA jacks are labeled. I believe they are pre-outs only.





Best of Luck.

can you please find a cod for keenmood krc-585/m3
thank you