2005 passenger power sliding door problem

its alot going on if all that started happening at one time check the bcm. body control module.

I'd bet the motor burnt out. If you pull the handle and it opens a few inches, and makes a soun like the door is locked, you might have to get the motor replaced. You probably bought it defective. My 2005 Honda odessy has that same problem from wear and tear.

Try this... it fixed my problem whereby the 2005 Toyota Sienna passenger sliding door would sometimes open and sometimes not, yet I could hear the motor trying to open/close it. It cost me 20 minutes and 10 drops of oil, not $1200.

First, get the door open. It took me two weeks of constant trying, but it finally opened.

Next, remove the plastic covering of the inside door handle this way: locate the two screws on the forward edge of the sliding door near the child-safety switch: (the switch is a small lever near the door latch, on the forward edge of the door) loosen and remove the two phillips screws, one above the child-safety latch, and one below.

Remove the plastic cover to expose the gears for the door open/close mechanism.

There's a bunch of intricate plastic and metal parts in there, all coated with white grease. I used some 3-n-1 oil to lubricate everything in there thoroughly, In my case, there was one part that was a little void of grease, hence it "stuck" occasionally.

Test the system. If it's Okay, replace the plastic cover, and re-install the screws.

Now my Toyota Sienna 2005 door never fails to open or close.

You might try rehoming the door. Erase the sliding door DTC's by removing the No. 7 fuse in the under-dash fuse box and reinstall it. Then turn off the Main switch for the doors and make sure the ignition switch is in LOCK (0). Fully close the sliding door manually. Turn the ignition to ON (II) and then turn on the Main switch. Test the door operation several times. note: If you have an 99-04 Odyssey let me know the procedure is different.

We have the same problem, just opposite doors - the passenger slider will close to 80%, but the driver still functions fine. There must be an easier solution than new wiring harness/motor??

You may have to have the ECM rerogrammed with whats called a flash update. Its basically a software fix for the door controller. nContact your local dealership to see if an update may be needed and available. This is a procedure that can only be done by a dealership.

I just fixed my 2005 T&C sliding door. The wire in the plastic rolling chain is broken when resides right under the step pad. It took me 30 minutes to fix.

Go to this link.
http://wiki.answers.com/Q/How_do_you_replace_the_power_sliding_door_wiring_harness_on_a_2005_Town_and_Country_chrysler

Good luck!

there must be a switch some where , around the door to shut it off when door shut

I have the same problem with mine. But one thing that has worked for me is pulling the handle from the outside a couple of times. I don't know if something is sticking in there or if it resets the door. I hope this helps

I think you have a latch issue or a latch release issue, pull the door panel and try and release the door latch, pull the latch and try to see what if anything is wrong with it, also make sure the linkage going to the latch from the release handle is hooked up or not otherwise damaged.