E-10 appears on the display every time I try to play cd

Long time since the question was asked, but if someone googles it.
I have a Vauxhall Vectra -04 with a cdr 2005 radio/cd player.
Suddenly when I started the engine the radio showed ”panel” I turned radio of and then pressed AS and turned radio on while pressing AS, now it said ”10 safe” but I couldn’t enter the code. So I disconnected the battery and then reconnected it again, then turned ignition on, the radio said ”10 safe - - - -” and I was able to enter my code, then pressed AS and heard a beep, now it’s working just fine again

1.6 amp fuse in back of sub woofer is blown . it is on the rhs . you cant miss it 50 cent part.

Hello
If a disc has been put in the slot of the disc in play, Remove the disc, whose number is displayed, and press stop button.
Because of light or noise, the changer has detected a disc in the lot of the disc being played, even though it is empty. Check whether there is a disc in the displayed slot. With front panel closed, hold down "STOP " button for atl least four seconds or more.

Hi!

I dont't think that your cd-changer is broken. It may only need some cleaning. One year is time enough for dust to set on optical reader. I suggest to use a cleaning disk, available on every store selling optical media.

Hope it helped,

Bogdan

Your dvd/cd player is overheating, if you can try and move the station out to where it is more ventilated. It should fix the problem.

If you've tried more than one cd that you KNOW works with other cd players, the sensor in the cd player could be dirty or damaged. If it's dirty, carefully clean it. If it's damaged, it will need to be professionally repaired (unless you're feeling very brave...).

If it's clocking time on the disc predictably don't mess with the laser.

http://www.retrevo.com/support/Memorex-MX4118-Radios-manual/id/1082dj096/t/2/

Is the CD indicator lit? See page 18.

Press the PLAY/PAUSE > '' / POWER ON button to select CD; the CD indicator will appear in
the display.

CD ERROR DISPLAYS
CD Changers
E01:
The disc magazine is not inserted in the cd changer
E02:
No disc is inserted in the disc magazine
E04:
The disc is dirty, or the disc is inserted into the disc magazine
upside down
E99 RESET PROCEDURE:
Remove CD magazine by pressing eject button on changer.
Remove all discs from magazine and re-load empty magazine into
changer. Using the Radio RESET CD system by pressing and
holding the “ON”/”POWER” button for about ten seconds, or in
earlier models the “EJECT/6” button.


FM/RF Remote Controls
E99 RESET PROCEDURE FOR REMOTES:
Remove disc magazine from changer by pressing eject button.
Remove all discs from magazine and re-load empty magazine into
changer. Press RESET button on interface unit
WAIT:
The temperature is exceeding more than 55c(130f) and the cd
changer cannot be operated. When the cd changer cools off, this
wait disappears. When the RESET button on the interface unit is
pressed, this WAIT appears for a few seconds


IF THESE ERROR CODES STILL KEEP APPEARING
CONTACT YOUR DEALER.

Hi there!

1. Have you checked the manual for that?
2. Is it working before?
3. Have you tried different CDs? are they working?

The system may need to reset. Unplugged the amp from the power source completely and let it rest for at least 5 minutes.

The illumination can only be controlled from the main remote. Adjust the prongs inside the remote and this should fix the issue.