I need a flame generator drive motor E200506 or E199324 for my CFI-E200 Chimney Free fire place. Where can I buy one? That motor has to have 22r/min

Does it work ok tell the blower motor turns on?

They are very expensive Gas wall fires with built into a vent purification system that is built in to the fire they look real cool but are really expensive, But they do save all the cost of having to have a liner flew fitted up your chimney or fitted into your firplace, but
I have heard that if the internal vent stops working its as expensive as buying another fire, Hope this helps

That lever operates the iron plate which goes from vertical to flat to shut off the flow of air up the chimney. When the fireplace is not in use, it needs to be closed to prevent drafts or air flowing in or out the chimney. It must be open to use the fireplace. Look up inside to see if you see daylight for it to be open. If it is not open when you build a fire, the smoke will come out into the room instead of going up the chimney.

Gas Fireplace Manual - Gas Fireplace Instructions: Mendota ...

mendotahearth.com/gas-fireplace-stove-owners-manual.php

Mendota gas fireplace manuals and gas fireplace instructions for Mendota ...Mendota Gas Fireplace Insert FullView Model FV33i PF2 - Installation Manual

[PDF]FIREPLACE HEATER - Crane

crane-usa.com/assets/.../Fireplace_Heater_2013.pdf

by C Care - ‎Cited by 2 - ‎Related articles
your fireplace heater, please contact Crane. Customer ... This instruction manualapplies to the following models of the Fireplace Heaters product line: Color.

I would order a Chilton manual for your truck. eBay is a good place to get one ($25).

Yellow flames is lack of air blocked burner ,blocked injector , low gas pressure .

I would put a smoke pellet up the chimney to see if you have a pull on the chimney to see if it is not blocked , or if you have down draught what sort of pot are you thinking of putting on the top ?

Hi Walter...
The cheapest one (from seller with good rating) is AC 220 240V 33RPM 4W Turntable Synchronous Motor TYJ50 for Microwave Oven on amazon.
Take a look, and if needed feel free to contact the seller.
I hope it was helpful.
enjoy

these are common in microwaves check appliance parts stores

Pressure Relief
Special Tool(s) EFI/CFI Fuel Pressure Gauge
310-012 (T80L-9974-B) WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related component. Highly flammable mixtures are always present and may be ignited, resulting in possible personal injury.
WARNING: Fuel in the fuel system remains under high pressure even when the engine is not running. Before servicing or disconnecting any of the fuel lines or fuel system components, the fuel system pressure must be relieved to prevent accidental spraying of fuel, causing personal injury or a fire hazard.

1. Remove the schrader valve cap and attach the EFI/CFI Fuel Pressure Gauge.

NOTE: Open the manual valve slowly to relieve the system pressure. This may drain fuel from the system. Place fuel in a suitable container.
Open the manual valve on the EFI/CFI Fuel Pressure Gauge slowly and relieve the fuel pressure.

Filter Removal

1. Relieve the fuel pressure; refer to Above.
1. Remove the fuel filter (9155).
   1. Disconnect the fuel lines
   1. Remove the fuel filter from the fuel filter support.
   
Push Connect Fittings
Special Tool(s) Fuel Line Disconnect Tool
310-S039 (T90T-9550-S)
1. Relieve the fuel pressure; refer to Pressure Relief in this section.
1. Disconnect the safety clip from the male hose.
Install the fuel line disconnect tool and push into the fitting.
Install the fuel line disconnect tool and push into the fitting. Separate the fittings.
• Inspect for damage.
• Clean the fittings.