Lights will not turn on aqua surge dishwasher

inlet valve is the aqua stop long hose to tap has a solenoid at tap end that is likely your fault

There may be a filter after the aquastop pipe which is blocked. This is usually at the back of the inlet valve. Also, the inlet valve may no longer work.

the valve and wiring can be replaced you cannot remove it altogether as it wont be able to fill up, bosch aqua stops are normally powered solenoids that also double as the water inlet valve unlike most other aqua stops

looks to me like as if the direction of the hose is incorrect. Check to see if there is a direction of flow arrow on the hose and point that arrow away from the tap towards the machine.

could be the microswitch on the door catch.

My start button doesnt work on the panel

Hello,
In the water inlet hose close to the valve on your supply end,its encased in a big ( 2") plastic housing with a brass fitting.

Hope this helps.

create an inverted trap in ther dishwasher drain line so the water cant back feed

REPLACE WATER INLET SOLEENOID

Most of the dishwasher has a Thermal hold period in which the machine will not advance to the next cycle until the water temperature reaches a specific degree. it is possible that your aqwa sensor/or heater is bad OR as in most of the cases, the Timer relay that is responsible in turning the heater on is stuck open, in this case you need a new timer. So,Check Timer/Aqua sensor/Heater