Hitting glass nothing happends till unit is hot

You need to wait till the time you programmed it for. did you do that? If all programmed for instant operaton and nothing is happening then the unit is no good.

just fill it till it hits the level mark, then crank it till oil light goes out, then recheck after runs for a few seconds, to level in sight glass.

Pinball machine glass tops are made out of tempered glass, they would have to take a direct hard hit to break. I've been playing for years and nothing has scratched or cracked yet so you shouldn't worry about it.

my first thought is a bad heating element, but on thinking more it may be a bad controller. The unit is running the element at max. till the breaker says no more! Hot cord is not good!
Is very hard to diagnose via the net. Might want to try a electrician? to get it narrowed down.
sorry, but i'd not use it till it gets resolved.

MOST OF THE TIME ITS A PROBLEM WITH THE WATER NOT HOT ENOUGH AT FIRST FILL. RUN YOUR SINK ON HOT TILL IT GETS HOT THEN START YOUR DISHWASHER. ONCE THE GLASSES ARE COATED YOU NEED TO SOAK THEM IN WHITE VINEGAR

If you need further help, I’m available over the phone at https://www.6ya.com/expert/dude_653d05454b389bba

absolutely nothing, they are cycling properly to keep the glass top hot
you are not cooking wioth the heat of the element,
but with the heat the glass absorbs from the element
if they are all doing it,,,, it is normal trust me
i have handled this call about 500 times since glass tops first hit the market

you can try to comand de doors puting the key in the door till all the windonwns are down than put than colse again maintainning the key in the close position

control board low voltage problem