Right front (large) burner indicates hot, won't work, flashes F153

Take out the right front burner and use your multimeter to check it for continuity. Only then can you be sure that the error code isn't lying to you.

It is my guess, that with an error message so specific, that if no burners are working, it is not the front right burner at all. Hands on testing is the only way to be sure.

F152 means the right front burner has failed, the sensor in it is bad, the burner will need to be replaced.

error code F152 ' Appliance Video

The element is $225.00 so it is not something to change on a guess. Full testing procedure here, or call for a Service Engineer.

https://www.appliancepartspros.com/answers-for-ge-element-radiant-lt-wb30t10080-ap3188020-question-148609.html


..

Here is what the error code means

Hi Tricia, I assume this is a GE unit?

Check this link from Appliance Blog that deals with this problem.

Appliance Repair Forums

This link lists the error codes for your cooktop: Needapplianceparts com

Specifically, it's a "sensor break" in your front and center burners.
The solutions they recommend:
* Verify element temperature sensor is correctly connected to the generator circuit board
* Replace element if temperature sensor resistor value is not approximately 1000 ohms (blue wires) at room temperature
* Replace associated generator circuit board

Most likely it's the switch or element that's bad. Unless you wish to call service, start with the switch since it's probably cheapest of the 2.

Heating element or control board needs to be replaced.
oven repair in orange county, ca
appliance repair orange county, ca

Call the service tech it;s under warranty and, this model is notorious for this fault

Have SAME EXACT issue - F113 on Left burner. Indicator says HOT and not even on. Called a service company (NOT GE SERVICE). They said the Element Radiant is no good and must be replaced. Part is quoted as $323.98 !!! What a rip off from GE !

Hi - I've been having the same problem. GE tech service in St. Louis, MO has been a joke. 1st tech call cancelled 30 minutes before appointment. 2nd tech call to diagnose the F153 code I had already provided when I scheduled service on-line cost $74.95 and the tech didn't have the part on his truck. 3rd tech call a new tech shows up, has no knowledge of previous call diagnosis, opens the box sent to my home by GE and announces that the previous guy ordered the wrong part! We're on the 4th call. My cook top right front burner has not worked for a month. I've contacted GE corporate. The part you need (at least I need) for the right front burner which is a large burner is: WB30T10062. If I knew how to, I'd repair this myself. I don't have the extended warranty. The part is covered because my cooktop is only two years old (parts warrantied for five years) but labor is estimated to cost almost $200....plus the $74.95 "diagnostic" visit. A total rip-off. My advice, if you've got this cooktop, it's still under warranty and you aren't using all of the burners on a regular basis: start using them! The tech guy said most people use that front right burner alot and it eventually malfunctions (code F153). His suggestion was to start using the other burners on a regular basis, too, so that when they go out, at least the part will fall under the five-year warranty! When this cook top is done, I'm going to get a gas stove with "old fashioned burners" and it won't be GE!