Unable to see if an internal extension is engaged

PDF]Telephone Features Programming Guide - Avaya Support

https://downloads.avaya.com/css/P8/documents/100142941 AvayaNORTEL NETWORKS is a trademark of Nortel Networks. ... All other trademarks and registered trademarks are the property of their ... One-line and two-line displays . ...Memory buttons . ... Call anomalies for telephones without line buttons . .... Select how you dial your calls . ... Receive a busy signal on an internal call .

Norstar How to program phone how to program voice mail ...

www.phonserv.com/1_PDF_user_guide_meridian_norstar_phone_syste...

Nortel Networks Meridian Norstar How to program voice mail phone feature codes ...Modular ICS KSU must be programmed with an M7310 or a M7324 telephone. ... Lift handset, press Voice Call key or press the Feature button, then press 66 2. .... At the LOG: prompt, enter your mailbox#(extension #. and your password all ...

[PDF]N QRTEL NORSTAR

When you call an internal extension and the extension is either busy or ringing, you can invoke the Ring Again (Call Back) feature. If Ring Again is activated when the dialed extension is ringing, you will be notified when there is activity on the phone and the phone becomes idle. You cannot use this feature on outside lines, and while your phone is idle.

Hi Amy, you can change the name for an extension, but it will change the name for the extension for all the phones.

It is best to do programming on a T7316, M7310, or an M7324

1. Feature **23646
2. Password: 266344
>>>your password may have been changed by your phone company. contact them for the password.
3. Scroll to General Admin
4. Go to Names
5. Select Set Names
6. Enter in the DN of the extension you would like to change
7. Use the dial pad to change the extension.
8. Press Rls when finished (handset with arrow facing down)

There is a feature built-in to the norstar system called "Set Relocation". When this feature is turned on, you can move a working extension to an unused/activated jack and the extension, features and mailbox will stay with the phone.
Have your system administrator turn the feature on, then move up to 2 phones at a time. The phone will go through 2 bootup sessions - be patient and don't unplug the phone.
Good Luck!

The do not disturb might be active on the extension that your trying to transfer to.On the extension that your trying to transfer to, enter feature #85 to cancel out do not disturb.

Are you using the installer password or the admin password?

Well ~ eagleeigh731 has it mostly correct, do what he said to do and get into the programming --> find SYSTEM PRGRAMMING --> hit next until you find CHANGE DNs--> OLD DNs (this is the old extn#) 222 then type in NEW DN 431--> then hit the end or release button.
Voila your new extension is now there... to check dial FEATURE 0 then press the intercom button, the new extension should be there.

We would like to change the name displays on our phones

must drop the whole programing and start from scratch. it called dumping.