No picture - red stays on, green light clicking on and off

My Loewe did the same thing tonight. The picture went blank and the rered and green light came on together. Any suggestions?

Hello,

My LOEWE CAL 232 will not power up. When the power button is pressed, the monitor turns on, with the LOEWE on the monitor, then the TV continues with the previous activity (antenna, DVD, VCR etc.). Now all that happens is

1. the red light comes on

2.after about 1 second the green light turns on for about 12 seconds

3. the the green light turns off for about 1 second

4. then the green light turns on again for about 12 seconds

and this continues until the power button is pressed to turn the TV off. During this time, the monitor does not turn on and the only sound I hear seems to eminate from the power button.

Any thoughts?

My Loewe Aconda 81 HDR TV will not turn on. When I press the power button the green light comes on but the red light stays on with it and after a few seconds the green light goes out and the red light stays on. Any help please.

I know a lot about these sets---I did warranty work on them when they were new and later---Set was designed in Germany and the company based in England---for a while the parts were very hard to get---but the last time I fixed one there was a Parts center here in the USA.

Set is basically modular in design--meaning if the problem cannot be traced down and found you can buy from the USA SOURCE a replacement board.

Answer a few questions and I will try to help you.

1.) Before the set failed did the picture fill the entire screen from right to left and top to bottom?

2.) When it shuts off does the power light stay green or go to red? (standby).

3.) Does the set make any unusual sound or have a burning smell?

THERE IS ONE VERY COMMON PROBLEM ON THIS SET--THERE ARE ABOUT 8 CERAMIC CAPS ON THE "MAIN" board----One of them opens (does not short!)

This cap is almost in the middle of a group of brown caps (the larger ones never fail--it is fairly small) I think I still have some new ones here--if you need I can look for them and tell you what markings id the cap you are looking for.

Someone has to unsolder each cap from the board and check them with a cap meter---if they find one open---this is the problem.

Regards, SD TECH

Ur power inverter board is dead.
U need a new one.

My problem turned out to be the primary power supply. I had a Loewe tech guy fix it, and it cost $187.00 (Australian) for parts and labour.

This is not my area of expertise, however the link below will display solutions to cases that are similar to yours on same model aconda 30'' with same problem:
http://www.fixya.com/search/p18875-loewe_aconda_aco9303_30_tv/red_light_is_always_on

hope it may help

flyback transformer...get a pro to fix it

Power supply problem, Loewe issued a PSKIT for these items. part number 90415.900. If none of the secondary fuses are gone kit required (All parts should be fitted)

Could be loss of voltage on secondary or problem on Power supply. Check 4/5 (depnding on chassis) wickman fuses on secondary if none are o/c then replace power supply components with Kit from Loewe. Part number 90415.900.

Should take tv engineer about 1 hour (max) to replace parts form kit.