Question about Televison & Video

2 Answers

V-chip block on Jensen JE2269 Digital LCD_TV

.We have the above described TV installed in our motor home.  We plug in to cable at RV Parks or use Dish satelite when cable is not available.  We receive all channels except when a sporting event comes on TBS a blue screen appears and the words "V-chip block   None" appears and we cannot view the sporting event. All other programming including commercials during the sporting event comes through on this channel.  We have checked the remote to the TV and the remote to the Dish and it appears that nothing is blocked as "OFF" appears next to types of programming that you can block.   We bought the motor home used so we dont have any passwords.  Any clues.

Posted by wamu on

  • 3 more comments 
  • Anonymous Nov 12, 2007

    I have the same problem with the same TV only on one channel. I have the book and all v chip settings are off. I also emailed audiovox and did not even receive the courtesy of a reply. Good luck, I hope we don't both have junk.

  • arrowest Jul 14, 2008

    I have the same problem with my Jenson TV on my boat on one channel and its the most important channel I watch, the Weather Channel! I have also gone thru and check off settings!

    Any help on this problem?

  • Skip Ivison Sep 16, 2008

    I have the same problem with the same TV on my boat. I emailed Tech Support and have heard nothing.

  • Skip Ivison Sep 16, 2008

    I just spoke with Tech Support and they are aware of the problem and are working on it.

  • Skip Ivison Sep 17, 2008

    Did the TV come with your boat? Was your constant contact with Jensen or the people who sold you the boat? Was it under warranty? Sorry for all the questions. If you are able to respond please do so to my email address:



    [email protected]

×

Ad

2 Answers

Anonymous

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 54 Answers

I dont know but if any help the master password to jensen tv's is 1234 i am still looking into this.

Posted on Jun 29, 2009

Ad

Anonymous

If it helps any, I had the same TV with the same Weather Channel issue, also on a boat. It took months of constant contact but they ended up replacing my TV with a different model and after several months with the new one I have had no problems. This started in 2007 (I was the 11-12-07 post) and it took jumping through a few hoops to get the replacement. Good luck.

Posted on Sep 17, 2008

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a jensen Je 1911 dvdc, it will not stay on but 8 seconds help we have 8 days left


Jensen 19" 12-Volt TV/DVD - Camping World

www.campingworld.com > ... > TVs & Accessories > TVs

Rating: 2 - ‎2 votes - ‎$269.00 - ‎In stock
Where does one get a replacement remote for the 19 inch /dvd model ??/. 1 answer(s)... Need remote replacement for Jensen JE1911ABC. 1 answer(s).

JENSEN LCD TV Accessories - Jensen RV Direct

www.jensenrvdirect.com > Products > LCD TVs
Items 1 - 12 of 22 - We also offer video control centers, PAL tuners, and digital tuner boxes which will convert your analog TV signal into a digital one.

postheadericon JENSEN JE1914DVDC DVD STAND

dynastre.tk/469748/dvd-jensen-je1914dvdc-stand

Dec 27, 2015 | Jensen Televison & Video

1 Answer

Need help with rv tv


If signals by cable is digital, and your Tv is no a digital compactable one, you need a set top box to view cable programmes.

Apr 20, 2012 | Televison & Video

1 Answer

No sound on my jensen je2269 lcd tv


Check the audio/line pre-amp outputs from the TV to be tested on an external amplifier and if there is sound the fault is with the power amplifier within which can be a power loss or a damage on the output IC.
If there is no preamp output then the fault is in the SIF- sound IF and preamp. You will need a signal trace with an AF injection to test and confirm.

Oct 06, 2011 | Televison & Video

1 Answer

New jensen jdtv-1020 won't see either air or cable signal as TV2 with Dish DVR 625. An older Emerson color TV sees cable 100 but the new jensen does not see it during auto detect.


Hello, Matthew Gonzales with DISH Network customer service here. First thing to try is putting the TV on channel 73. At TV1, press menu on the remote, followed by 6-1-5 (system setup-installation-modulator setup), make sure that TV2 out is on cable mode, which should default to channel 73. If you're still not getting a picture, try performing a hard reset on the receiver. To perform a hard reset, unplug the receiver from its power outlet, wait 15 seconds, then plug it back in. The receiver reboots (which can take about 5 minutes), then check TV2 again. If there is still no picture, make sure all of the cabling is secure, and bypass any other devices (VCR, DVD player, etc.). If this does not fix the problem, please feel free to email me at [email protected] and I will make sure we get this taken care of for you.

Dec 27, 2010 | DISH Network DVR-625 DTV Receiver /...

1 Answer

We recently moved our dish ( we are in an rv) and now we get a signal on one tv only. we have dish network and a 625 DVR. we have moved many times and have never had a problem before. in order to switch...


5shades690,

Are you still having problems with your TV 2 off the 625 receiver? You have a cable off the back of the receiver, TV 2 Home Distribution. That's feeding to your TV 2 location. You might check to make sure it is secure. You can also see if that cable screws into a diplexer if it is being back feed through the satellite cables. These are all potential problem spots, especially since you said it was working before. I hope this helps.

Ray Calo
DISH Network

Jul 28, 2010 | DISH Network DVR-625 DTV Receiver /...

1 Answer

Okay i have a digital labs 19" LCD HDTV/DVD and it works fine until you hook it up to an antenna cable, then it wont give channels when i auto scan. what should i do? buy a new cable or is it the tv


I have the same problem. Seemed to work fine with digital cable, but after switching to Dish Network, no luck. If I plug the AV cables (red/white/yellow) directly into the dish receiver, it works fine. The problem happens when I use it as a second TV connected via the RF cable wire. My only guess is that the dish receiver transmits the signal to the second TV via NTSC ... and the Digital Labs TV only supports ATSC and QAM. Hoping someone can confirm?

Jan 05, 2010 | eVision Televison & Video

1 Answer

Does Jensen TV TS2750J have a digital tuner or will I NEED TO BUY A NEW tv for 2009?


all you need is a converter box or cable or some type of dish i just got direct tv installed today it works great. you dont need to buy a new tv.

Dec 11, 2008 | Jensen TS2750J TV

1 Answer

JE2269


Disconnect the TV From the DVD player and Try a Stand alone Start up there might be something wrong with the DVD player and need replacing. Give this a go and let me know how to went. Ron

Dec 09, 2017 | Televison & Video

Not finding what you are looking for?
Televison & Video Logo

Related Topics:

825 people viewed this question

Ask a Question

Usually answered in minutes!

Top Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76416 Answers

Cindy Wells

Level 3 Expert

6182 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Are you a Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...