Convert wine cooler into egg incubator?

SOURCE: U-Line 15WC Wine Cooler Problem

Cheak The Compressor relay is fault

SOURCE: danby wine cooler repair

I am having a problem with my wine cooler also.I found the upper evap fan not running.So i opened up the control board and plugged the fan that was not working into one of the other 2 sockets,and the fan worked.so i have a circuit board problem.If you go online to sears parts and repair.put in your model# and search,it will bring up a diagram of most of the parts available.And no it doesnt have to be a GE product.

SOURCE: compressor for haier bc112g

Dear friend,
ngfam at you service! happy to assist!

How old is this wine cooler! MY ADVICE BUY ONE NEW!
It cost $241 to buy a new one at the site below!
NOT WORTH THE MONEY FOR A COMPRESSOR
Or model #HBCN05EBB FOR $249 96 BOTTLES CAPACITY

http://www.buy.com/prod/bc112g-30-bottle-freestanding-wine-
refrigerator/q/loc/63024/203111423.html



If the dishwasher is 10 years or older its not worth investing money tofix it! The new ones are mush more efficient and clean better!

Either way this is a service problem to remedy!
Below I gave you a nation wide service thats very good!

We sell appliances for 65 years and I recommend this nation wide Factory repair service!

Call A&E Factory Service /They service nation wide
And are available 24/7 for making appointments!

If the appliance is 10 years old or more,it may make sense not to invest any money to fix it!

Happy to assist you,
PLEASE GIVE ME A GOOD RATING BEFORE YOU SIGN OFF!

SOURCE: Emerson wine cooler /ER2352

I had a similar problem and just solved it.
My cooler was leaking and had trouble keeping the proper temperature.
It was also making a buzzing sound which is what lead me to my solution.
BTW - The liquid that was leaking was condensation, probably because the unit was not holding a constant temperature.

Unplug the unit first - no need to get electrocuted.
These units use peltier cooling- essentially a large heat sink with three fans attached.
Click here for more info regarding peltier cooling.
The peltier unit is not repairable, but the fans are; which was what my problem was.
There are three fans on this unit, one on the inside and two on the outside.
Follow these steps to remove them.

1. Remove the rear cover. It is held on with ten screws. This exposes the two exterior fans and the peltier heat sink
2. The heat sink is held on with four screws - remove them and pull the heat sink out. The third fan is on a short wire lead, so be careful when removing the heat sink from the body of the cooler.
3. The two exterior fans are connected to a control panel, the electrical connection is easy to disconnect.
4. Once all of the wires have been disconnected, you can remove the fans from the heat sink.
   
5. The fans are screwed to a mounting plate, which is screwed to the heat sink
6. You must remove the mounting plate first to expose the screws that hold the fan to the mounting plate. The fans are typical computer case cooling fans
7. I only needed one fan, but replaced all three because I didn't want to do this job again.
8. I purchased my fans from Newark.com the prices were better than what I found at the computer websites. Also, these fans are much better than the original and will hopefully last much longer than the three I got from the old ones.
9. You need one of these and two of these. The total with shipping was around $30
10. You will need to splice the old electrical connection sockets onto the new fans using wire crimpers or solder them on.
11. Attach the components in reverse order and power on the unit.
12. These fnas may move more air than the originals, because the unit seemed to cool much quicker than I remember.
    
13. Total time for repair is about 45 minutes

SOURCE: Avanti wine cooler temperature problem

Fixya repair directory link
http://www.fixya.com/repair
this is the direct link for repair service enginers just select the proper unit of yours and your area  location.