Edimax Router BR-6140K Self-restart Problem

Are you the computer's Administrator? Reboot the wireless device and the computer. Repeat.

How to configure edimax router BR-6104K Problem with the Edimax BR-6104K Router

Be specific!!!! upgrade in drivers or device it self?

This link has a firmware update--- http://www.opendrivers.com/driver/236219/edimax-br-6104k-broadband-router-firmware-v3.25-free-download.html

Try to look for MTU settings on the router's admin page. Since your on DSL connection, set the MTU size to 1492 and save the changes. You need to power cycle the router after that. Good Luck!

Try reading the Quick Installationguide and see of that helps.
 
http://www.edimax.com/images/Image/QIG/Wireless/BR-6204Wg/BR-XXXX_QIG.zip

Well that is because torrents and other p2p apps open too many connections and the router can’t handle it. Try limiting the number of connections torrents and other p2p can use.

1You can run the setup CD or manually configure it using the user interface of the router.
2.Since that is a router all devices that will be wired to it should automatically get an IP address from it.
3.Since they will be connected to the router you just need to enable file sharing on each computer.

well, it just works now! :-) i can access the config page. idon't have a logical explanation.:-P

do you have apppoe connection or dhcp? release your ip address (ipconfig/release) set your modem to bridge mode then connect modem and router. try to connect.

marlon

HI,
  Actually in short  "you NEED A MODEM;"
In order to connect your router you need to connect a modem in "bridge mode'( bridge mode is nothing but a configuration on the modem)..


this is a picture of  rear side of a  router,,, you have to connect the modem into the wan port of the router (above),, and in port number 1,2,3,4 you can connect your computers,