Sharp UX110 Fax Machine (about 10 years old!)

The paper isn't properly loaded. remove the paper then there should be a lever near the paper loading section that you push or pull to let the paper enter the feeding area. put in paper and return the lever to the proper position. check your owners manual. to get a manual try www.sharpusa.com .

You haave a bad SCANNER Block, very expensive.

Mite need to clearthe memory of the fax machine

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

I called Sharp and they said if the paper was feed properly (and it was), then the problem is with the fax sensor and the machine needed to be serviced

You can't make it just receive.

Unplug the power cord for 10 seconds.

You probably need new ink / drum / toner.

do you hear the tires trying to pull the paper? if yes clean with alcohol ( may be slipping)

1. Just check & clean the dust in the original feeding area.
2. if not solved, clean the Document feed sensor or replace the same. But for this you need to open the body of the fax machine.

I need the operation manual

does it try to grab the paper?
do you hear anything happening before the beep?

The machine recognises that there is paper, then you should hear the communication, once it has the correct signal telling it the line is available for transmission it will feed the paper.

look at the tires and see if they turn to feed the paper, is there something in the way, do the tires turn,???

if yes clean with alcohol and try again, if the tires are too smooth then they need to be changed.