Cannot remember password need to rest it on ECOR264-4D2

The TVR 30 is shipped with one predefined user for the system administrator and
seven predefined standard users. The default system administrator logon uses admin
as the account name with a default password of 1234. You can modify the admin
password but not the admin user name. The seven predefined standard users are
labeled User1 to User7 with a default password of 4321 and level 4 access. The
administrator can customize the seven standard users and define their privileges.
Use the Users screen (shown in Figure 20 below) to manage users.
Note: When accessing the main menu for the first time, the system lets you pick
either an admin user or a regular user (User 4) by default. If you select User 4, enter
the initial default password of 4321.

Try Everfocus web site.

Thhe Factory Default is.
For user type in : admin in lower case .
for Password Type in : 11111111 .
thats 8 # 1 .

Here's the manual. Read it. http://www2.everfocus.com/downloads/manuals/ECOR_manual.pdf

Forgetting password please i need your help thanks

default password is 11111111

Default User and Password on Everfocus is usually
Admin
Admin

Nevertheless, you should contact your local distributor, and after providing the product serial number, they can generate a reset user and password, that shall be used only once, and then, you must enter a new user/password combo.

You can reset the password. If you have another computer and a USB flash drive - see http://www.rmprepusb.com/tutorials/12---bootable-usb-drive-to-reset-windows-user-pasword

The EverFocus EDSR Security DVRs use standard PC Parallel (PATA) hard drives. I have used ATA100 and ATA133 speeds with no problems. There are no PC-type settings required except as below. The DVR has it's own internal firmware and will format the drive to its requirements.

If you are using a SINGLE drive tray, the largest hard drive I know will work is 500 GB. Set the drive to Master and you are done with the hardware setup. (CS Select would also probably work.)

If you are using BOTH drive trays, the largest hard drive EverFocus says will work on the EDSR100 or EDSR110 is 320 GB. Set both drives to Master and you are done with the hardware setup. (CS-Select on both would also probably work.)

Do NOT set any drive to Slave!

Lock the drive trays; if you don't the DVR will not go into record.

Press the STOP key and then press the MENU button. Go into the SYSTEM menu and do a DISK RENEW. This will erase the hard drive and also prepare it for DVR recording.

Do this by using ► or ◄ to select DISK RENEW. Change NO to YES (by using ▼ or ▲) and press the ENTER button. Highlight YES again by using ► or ◄ and again press the ENTER button.

Press the MENU button to exit and reboot the DVR. Then press RECord and you should be recording.

i have a sandisk 2.0 gb conpact flash copies ok but can take 45min to copy 5 mins of suvalience