Stuck lens my camera fell on the floor and the lengs got stuck

Lens errors are fairly common. Usually it's sand or grit interfering with the lens extension mechanism. Or the camera's been dropped with the lens extended. Or the camera has been powered on, but the lens had been blocked preventing its extension. Or the battery ran down with the lens extended ... Here are some troubleshooting steps that you can try that may (or may not) correct it. They only seem to work for less than 40% of the lens errors, but if the camera is out of warranty (or repair cost approaches that of the camera), they're worth that try. Some of the later steps do involve some risk to the camera, so carefully weigh your options before deciding to conduct them:

Hi there, after fall in the floor , your camera's lens guider is broken & thats why its not able to came out fully & not doing proper focusing. Replace the lens guide pin. After that it will work fine like before. Thanks.

Time to send it in, the lens assembly has been jarred and bent. Send in for repair, or replace camera.

Hi,
    As in short answer you have to replace the optical lens assymbly.Because due to heavy jurk its motor called sledge motor stsrt malfunctioning and it can not be changed component level. For this please contact any SONY SERVICE CENTRE nearby to you.
Hope you will understand.
Thanks for using FIXYA!

Your lens may need adjusting. This info may help . Other People solved problem. Lots of Info on this link.

http://www.fixya.com/support/t102982-e_18_problem

try Googling "E18" and read about this error signal and the many possible fixes. In your case sometimes gentle (really gentle) inward pressure on the lens tube while turning camera on (or off) will get it going again. Best wishes

Sub aa()
'
' aa Macro
'
'
Dim a As String
a = "how are you this is dharani"
Dim leng, cnt As Integer
leng = 1
cnt = 0
While leng <= Len(RTrim(a))
If Mid(a, leng, 1) = " " Then
cnt = cnt + 1
End If
leng = leng + 1
Wend
If Len(RTrim(a)) > 0 Then
cnt = cnt + 1
End If
MsgBox Str(cnt) + " Words"
End Sub

your lens are stuck! did you drop the camera? you need to get a repair on the lens

http://www.lensbabies.com/index.php?r=GSLBGeneral&gclid=CJSbjPWUrI0CFQqgYgodlz7D1Q chek site you will find diagram

cameras & hard floors are never a good combo. Im no help, except to say that if it were mine, I'd email the camera manufacture that question, and I'm sure they'll provide some useful info.