Question about Brother DCP-8060 All-In-One Laser Printer
The counter reset method depends on the cause of the toner life end message and the condition of the newly installed cartridge.
When a USED toner is installed the reset gear is set to IN USE.
When a NEW toner is installed the reset gear is set to FACTORY SET.
Posted on Dec 28, 2014
unplug plug it back in, did you remove the protective cover and clean coria wire?
Posted on Dec 20, 2007
SOURCE: toner low, tone life end
There is a gear on the left hand side of the toner to reset the toner count this can cheated be rewinding it. Yes the design is to stop the refillers or at least slow them down a bit. If this fails purchase a new genuine toner but I have seen problems with the switch that resets the toner (Either the spring on the switch has popped off or the main board has failed).
Posted on Jan 21, 2008
You could try resetting the toner cartridge settings. OPen the machines front door where you would replace the cartridges. On the top panel you will see a "clear/back" button. Press it and on the display you will see a reset menu come up. Arrow to each one and hit the OK button. Press "1" to reset. Once you have gone through all close the front door of the machine and press stop to bring the display back to normal.
Hope this helps.
Posted on Oct 21, 2009
Tips for a great answer:
Nov 11, 2010 | Brother MFC-9440CN Laser Printer
Sep 07, 2010 | Brother MFC-7820N Printer
Jan 04, 2010 | Brother DCP-7040 Laser Printer
Oct 17, 2009 | Brother MFC-9840CDW Laser Printer
Jan 17, 2009 | Brother DCP-7020 All-In-One Laser Printer
Mar 10, 2008 | Brother MFC-8460N Laser Printer
413 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: