Question about Dell Dimension 4600 PC Desktop

Open Question

Conntecting front panel power switch to Dell 4700 motherboard

Posted by Anonymous on

Ad

5 Related Answers

Anonymous

  • 1 Answer

SOURCE: connecting front panel leads of generic case to 4600 motherboard

b9bfa92.jpg



-MrSlickShoes

Posted on Mar 20, 2009


leecom72

Lee Hodgson

  • 4810 Answers

SOURCE: Proper pin numbers to install inserts in a Dell SATA 34 pin GX270 motherboard

Hi there.
Get a strong flashlight and a magnifying glass (if you have one). On the motherboard look for the front panel, it should be marked PWR and coloured green, also the plug that connects to it should be marked PWR_SW. On some boards there are no colours but the markings are the same, so take a good close look.
Have a look at these pictures for an idea >>>>>>

7b784c6.jpg

104b755.jpg
Please post back with the results and any more advice if needed.

Good luck and thanks for choosing FixYa!!

Posted on Jun 01, 2009

Ad

computerscot

  • 166 Answers

SOURCE: Front Panel help for Dell Dimension 4600

Most Dell's have a connector that all of the front panel wires go in to. That connector should only fit one place on your motherboard. If you use a flashlight you may be able to see some writing on the motherboard that will lead you to where it goes.

Posted on Jun 17, 2009

Anonymous

  • 2777 Answers

SOURCE: I have a Dell Dimension 4700 with M3918

That Xonar is an amazing card, as an aside are you able to do bitstream successfully to your receiver? Dolby HD and DTS HD successfully? If so I may just end up getting one of these cards :).

You should be able to do what you are looking for by just almost "breaking" that 10 pin straight line connector in half. I believe half of it is the AC97 and the other half is the HD connection, you can't really hurt anything by trying it one way or the other. Just try hooking 5 out of the 10 pins onto each row of jacks and test. You should also need to enable the FP headphone support in the Xonar software, it will look something like this screenshot here... as long as it is detecting the front panel jack correctly:

ae737da.jpg

I hope that picture shows up large enough....

Posted on Sep 19, 2010

Anonymous

  • 142 Answers

SOURCE: DELL GX 520 Motherboard power led

you should replace the motherboard or the power supply of your computer. to determine which one to replace is a simple test. disconnect all that is connected to the motherboard and if the problem is still there, then the problem is the motherboard.

Posted on May 06, 2011

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

I have a dell dimension 4700, soild green light, no beeps, no picture. just bought a used power supply.

First to be check is your power supply. Used power supply or brand new ones, does not matter as long as it is working properly, with correct voltage and ampere rating. Check your power supply with a voltmeter. Please take note also the total watts you need.. If your power supply is running good, problems will go down the line, the Motherboard. Remove all devices (hard disk, cards, memory, etc) just the motherboard, just to see if the motherboard is working right. Your should be hearing a beep sound indicating that the board is alive. If yes, you may reinstall the rest of the devices you removed.
0helpful
1answer

What kind is motherbourd

The Dell Dimension 2400 motherboard is proprietary to the Dell Mitac Chassis. It should work in any Dell 2300/2350/2400/4600/4700 case. The main item is the Dell specific power/control panel connection. If you move the board take the control panel with it.
(Personally, it isn't worth the effort)
0helpful
1answer

Dell desktop 4700 problem

Flashing Amber power LED indicates a bad power supply.

http://www.newegg.com/Product/Product.aspx?Item=N82E16817822008&cm_re=atx_power_supply-_-17-822-008-_-Product

If the LED Is SOLID amber, it is likely either a component connected to the Motherboard or a bad motherboard
0helpful
1answer

Have a dell dimension 4700 with orange steady light?

Turn the machine off and unplug the AC power then hold the power button in for about 30 seconds to drain any residual power. Plug it back in and turn it on, when you see the Blue DELL word press CRL+ALT+D and this should run a diagnostic on the hard drive. If it runs ok you will get a pass or fail on the hard drive. If you cannot get the diags to run you might have a bad power supply or motherboad/processor. I would find a known good power supply and try it before the motherboard.
0helpful
2answers

Trying to put 4700 back in service. When I plugged in power cord, the front amber light came on and stayed on. No lights on back (all off) and fan runs at high speed. Any thoughts? Thanks- Terry in Texas

System is in a NO POST mode.

Remove all external connections except power, pull any PCI Expansion cards, Make sure the 4 pin connection for the CPU is connected to the Motherboard. If the symptoms do not change, then the motherboard is most likely bad.
0helpful
2answers

Front Panel help for Dell Dimension 4600

Go to dell site and query for *********** board specs. Then query for the pinouts on the board. Or goodle dell optplex+motherboard+hardwire connections. good luck
Not finding what you are looking for?
Dell Dimension 4600 PC Desktop Logo

Related Topics:

39 views

Ask a Question

Usually answered in minutes!

Top Dell Computers & Internet Experts

Ekse

Level 3 Expert

13435 Answers

Mandeep  Singh
Mandeep Singh

Level 3 Expert

1184 Answers

Michael Thomas
Michael Thomas

Level 3 Expert

3056 Answers

Are you a Dell Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...