CIRCUIT BRAKER FOR 10AJB48A01 WHERE I CAN BUY IT

It is drawing to much load for the circuit braker . check the power the machine uses, ( on the plate on the machine) then check the power rating on the circuit braker, if it is rated above the power of the washing machine there is to much load on that circuit. and another cable will have to be run for the machine.

One year labor and 5 on the compressor only. and it is 14 years old right?

unplugging it while it was runnong shouldn't damage it, probably just the circuit braker. check to see if there is a button or some type of circuit braker on the unit and reset it, if it does not have one check the circuit braker that supplies it power. (in your braker box)

It should be connected in series with a circuit. Since a circuit breaker acts as an "over current" switch it will be connected just an on/off would so as to "open" the circuit during an over current condition. This will remove power from the circuit.

sounds to me that the breaker is getting weak,try replacing breaker with new one,if it still trips then you have electrical problem in a circuit.

they ussually have a circuit braker, some times built into the switch sometimes circuit braker is in the fuse box. also look under the hood for a burnt fuse link. yhey are usually in a little plstic box mounted on the fender

The orange wire is the power wire for both seats.It gets its power from the power seat circuit braker (20 amp) located at the body relay block.It is located behind left side of dash near fuse block. Remove circuit braker and check for power in body relay cavity that you pulled the relay out of if power is on one side change circuit braker and if no power on either side then you have a bad main fuse near battery or under hood in main fuse block. Joe ASE Master Tech

You probably have a burnt out element. They almost always short out when they burn out. If it is a coil unit it may be visible. A smooth top unit can't be diagnosed without removing the top glass. Most of the time you can do this yourself. Sometimes when a burner goes it will ruin the switch also.

The ciruit breaker might not be of sufficient rating. Tell us what is the number written on the breaker?