Question about Washing Machines

1 Answer

Samsung smart wash b1245s doesn t work

I have a samsung smart wash b1245s washing machine.last week i was using it and it stopped working.


i tried to restart and didn t want to go.

the day after i tried to put it on and strange enough it started .... i tried all the program and it seemed ok.

However after about 25 minutes when the spin started machine stopped again. and didnt want to go further.


I cleaned the filter tried again and it started, tried all the program and it looked ok.   .....then stop again.


Behind the eletronic panel you could hear a little sound like when two cable are not touching properly and do a sound like zzzzzzz.


i removed the cover checked all the little plugs and i started the machine with the spin program.


it finished with no problem.  fine let s put the clothes accumulated in a week....


when the spin was half way showed the error DE (door open) but in a second disappeared and the machine went on by itself, then after few minutes after again same error appeared and machine stopped.


tried to restart again but now it won t start at all and show me the error DE.


i disassembled the door circuit cleaned (it was like a little short circuit appened) but machine sitll show same error and doesnt start.


is there anyone that can tell me what is wrong?

Posted by on

  • 1 more comment 
  • Anonymous Sep 24, 2008

    Same error DE

  • Anonymous Sep 27, 2008

    I am having the same problum with my machine .Kindly guide me regarding my problum .

  • Anonymous Mar 23, 2014

    The filter has been checked and clean. The washing machine washes until second last step and then again gives E-05 error. Can you show me how to clean filter and tube.



1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Motor brushes are worn and nead to be replaced easy job if you turn washer on to its side remove the 2 screws at the bottom and take off the plastic panel you can see the motor and the brushes are red plastic bits remove them and replace with new ones that should sort out the problem and cost about £25.00 to do .

Posted on Jun 27, 2008


1 Suggested Answer


6ya staff

  • 2 Answers


Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a F&P washing machine Smart drive 603 about 10 years old, that has stopped working. No power, no lights, I am guessing electrics. Is it worth fixing? Not sure if it is terminal or not!

Ten years is a lifetime to a washing machine. If the total cost of repairs equals 50 percent of the cost of a new machine, the old one should be replaced.

Jul 12, 2016 | Washing Machines

1 Answer

My parents bought a Haier HBF655TEME washing machine last year december. Last week it stopped working. The door light stays on continuously when clothes are put in and the door is shut and it doesn't...

It is possible that the door switch has failed as the bulb is ON even when the door is shut . This indicates that the SWITCH is not cutt off and so the program controller will not allow the module to go forward or work. It is needed that you start from this point to use a multimeter to check the switch/ poles contact to confirm.

Jul 01, 2011 | Washing Machines

1 Answer

I have a samsung smart wash B1245S 6kg . when i set it on for a quick 30 min wash it will fill with water for about 10 mins . Then it will cut out and 4E will flash up on the digital display

Display shows 4E.

Water Supply Error occurs when water level frequency does not show changes more than 100Hz or water is not supplied up to the preset water level after 10 Minutes or more at the time of initial water supply. The error status can be cleared by turning the POWER switch OFF and back ON.

Dec 17, 2010 | Samsung Washing Machines

1 Answer

Samsung washing machine b1245s makes a grinding noise but wont spin...any ideas why and how to fix the problem?

i would grab a towel and check the pump for grit
and things that dont belong
may not be the actual problem but thats whered id start
have a great day

Oct 09, 2009 | Samsung B1245 Front Load Washer

1 Answer

I have a samsung B1245S washing machine error 53


5E is displayed if the water level frequency detected is 25 KHz or less in the initial phase of the UNB -detecting cycle. The Water Drain error can be cleared by turning POWER SW OFF and back ON.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.

Feb 02, 2009 | Washing Machines

2 Answers

Samsung smart wash B1245S SE error

you need to drain the washing machine by removing the little door below the drum door and pll out the the hose with a white knob (beware alot of water comes out so have a couple of pans ready. the fault means that there may be a blockage in the debris filter (next to the outlet hose yuo just pulled out) am sure you have prob already discovered the fix by now though!

Jan 12, 2009 | Whirlpool LTE6234D Top Load Stacked...

5 Answers

Samsung b1245s washing machine

The error code HE2= water heater error (The heater element did not getting hot)
Unplug the machine to reset this error.
Try different cycle let see you still getting the same error.

May 07, 2008 | Samsung WF337AA Front Load Washer

2 Answers

Bosch classixx 1000 washing machine - stops on spin

Washing machine stops at the spin cycle - light flashes. Have to drain water out manually. Happened last week and was then able to run an empty rinse cycle. Machine worked normally for another week. Same problem today but have had to drain water manually from the drum after trying an empty 90 wash and rinse cycle (both stopped on the Spin and flashed). Any ideas? Thanks. x

Apr 29, 2008 | Bosch Classixx WVF 240S Front Load Washer...

1 Answer

My samsung smart wash b1245S 6kg washes but won't spin, it displays an EU message on digital display, what is wrong ???

its your drain pump

must be a common problem on this machine. i have had to change the pump 4 times now in the 4 years i have had it.

they are about £8 off ebay including the postage

Apr 14, 2008 | Washing Machines

Not finding what you are looking for?
Washing Machines Logo

Related Topics:

858 people viewed this question

Ask a Question

Usually answered in minutes!

Top Washing Machines Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1481 Answers


Level 3 Expert

85216 Answers

Brad Brown

Level 3 Expert

18127 Answers

Are you a Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides