Enmar lcd tv

Here are some steps to tune a Teac LED/LCD digital TV without a remote:

1. Find the TV's on-screen menu buttons on the TV itself (often located on the side or bottom of the TV)
2. Use the arrow buttons to navigate to the channel setup or tuning menu
3. Select "Auto Tuning" or "Channel Scan" and follow the on-screen instructions to scan for available channels
4. If the TV has manual tuning option, select it and input the frequency, symbol rate, and other information for each channel you want to add manually.
5. Once the tuning process is complete, the TV should display all the available channels. If you are unable to access the menu without a remote, consider using a universal remote that is compatible with your TV or obtaining a replacement remote from the manufacturer.

Go in to the TVs menus, choose the TV Tuning options. Follow the menu path until you find the option for Auto Tuning.

That's about it. Not difficult.

try calling cable operator

try with another tv if it dosent work on that too your 64 is passed away

Try tuning it manually instead of Autostore...(check system if compatible)

I recommend taking to service center.

Check your TV settings and make sure your tuning is set for cable (may say "cable" or "CATV"). Right now you'll probably find it set for "air". If the TV is set to tune off-the-air, cable channels 2 through 13 work normally, but above that they aren't detected. Once you set the tuning mode to cable, rescan channels and you should have them all.

Download a User Manual or Quick-Start Guide free from www.skymediauk.co.uk/datasheets/manuals.php

Hi Max,
I an not familiar with Sky TV, I assume it a Cable or Satilite Service.
Here are a few things to check.

1. Press the INPUT button on the TV remote or on the TV control panel, cycle through all inputs and see if you get a signal.
2. From the TV's Video Menu, set tuning band to Cable and not to Air or Antenna.
3. From the Video menu Scan for channels, there should be a Auto Scan option.

Try these and let me know how it goes, I can be of further assistance.
Lone99star

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/jason_77a19afa8d604dee

Because you have DirecTV there is no need to use auto tuning. You simply changed inputs on the TV when you started auto tuning. Just use the input button on the remote to go back to the Direct TV receiver. Most likely it will be under Component (Color Stream) or HDMI input.