Ricoh 1022 image repeat problem still same

Check paper in tray and make sure it was set for correct direction (8.5x11 landscape or portrait).

Hello sir; You have to replace drum and developer meanwhile you have to clean up image roller, then it will take care the problem.

you have to go into service mode

The fuser part number for a aficio MPC 3000 isB2374053 USA
and B2374054 for EU

Hi sir; No matter who told you to replace, the hot roller is the most possibility, the next item also last item you need to check is drum unit (drum cleaning blade,[replace it ], image transfer roller [clean up by alcohal] and drum [ depend condition ]).

The problem is that the Upper fixing roller needs to be replaced... Most likely the coating on the roller has worn off and the bear metal is exposed and the toner stick to the metal and reprint it futher dow the page.... It could also be uneven pressure with the upper and lower fixing rollers... It may be a broken bushing or ball bearing... Good Luck

bad hot roller or pressure roller

Hello sir; Follow the steps to reset;
1, press "clear mode", "107", then press and hold "clear/stop" key untill display change.
2, enter 5810, then press "execute" on screen, then press "close".
3, turn power off then back on, it will go back to normal.

problema ricoh aficio 1022 copia en blanco aparece codigo
sc 193

some times the nipple (cover) of the toner stays in the toner holder this wont allow the new one to be opened