Epson Acculaser CX11NF Service req C1120

Rom checksum error.
All error messages are listed at the following link:

http://einfo.thecircledelivers.com:8081/Techs%20Folder/Manuals/Epson_AcuLaser_CX-11N,NF_Field_Repair_Guide.pdf

The "Service Req E537" error message means that the fuser unit has failed to warm up. Please see the following article for assistance with this message: http://www.epson.co.uk/Store/Printers-and-All-in-Ones/Epson-Aculaser-C1100/Drivers-Support?target=article&extn=.html&articleId=1265

Service Req C0082 CPU error (TLB miss exception [Load/Fetch]). Generally it is an envirnmental problem. Power the printer off and disconnect all cables. After one minute reconnect the power cable only and power on.
Then try a Starus Sheet, press the right arrow button 3 times. If the sheet prints then the problem may bea the network or corrupt documents been sent from the Netwrok or PC.
If the issue remains then you will need a new part so you will need ot contact Epson for further assistance.

Hi.. To fix the E527 error, close the front panel (cover A) and open the top cover (cover B). With the photoconductor unit removed, the toner carousel will rotate. It only rotates if cover A is closed all the way. You can easily rotate the carousel to a position where you can remove/reinstall the toner cartridge if stuck.

Thanks
jim report_dis_text_13954 = 'We\'re sorry but you must be signed in to report inappropriate material. Click the button below to sign in or register.

• Sign In / Register »

• Cancel »

';

Hello,

Can be a tough one.

1st - Open the ADF & make sure that the 2 little Sensor tabs move freely.

2nd - Lift the ADF & check that the White Plastic Paper Guide is "down in the slot" & not resting on edge of the white flat bed scan pad or overlapping the scan pad.

For some C Error Codes

Check for electrical interference from external devices.
Disconnect the Printer from all devices, and run a test print..


Here are the "c2011 error" fixes per the manufacturer:

Replace the Automatic Document Feeder.
Replace the Scanner.
Replace the Main Board.
-------------------------------------------------
You might try unplugging the ADF & see if you can operate without it.

If you unplug the scanner, the printer might not function.

-------------------------------------------------

You need a new photoconductor

CPU Error. Mainboard is faulty.

I imagine not. Usually, those sticky plastic strips are there for shipping purposes. Where exactly are the strips? Knowing that will help me advise you further.

I had this problem. Try unplugging any usb connection to the computer, turn off, then turn on and then try a stand alone copy. It was my USB connection to the computer which had locked up the copier.
After this it was fine.

Service Required E521 error: BTR 2 Error The input of 2nd BTR Retract Sensor does not change when 2nd BTR is initialized. There area couple of things that cause this problem. I would suggest you obtain a service manual from http://www.TheServiceManualShop.com If you don't see your manual listed, drop them a line to see if they can email it to you. Hope this helps