Washing machine leaking

Locating And Repairing A Mystery Leak In A Front-Loading ...

? 3:55
www.youtube.com/watch?v=3D5q1ynWb-U
Jul 28, 2012 - Uploaded by SamuraiRepairman ... source of a leak in a front-loading washing machine and then mercilessly repairs it. ... LG Washer Repair & Diagnostic -Leaking Water from front & bottom ... Samsung Front-LoadWasher Disassembly - Washing Machine ...

Samsung vrt steam washer leaking - Fixya

www.fixya.com/support/t13638559-samsung_vrt_steam_washer_leaking

Jul 15, 2012 - Samsung vrt steam washer leaking - Samsung WF338AAB 4.0 cu. ft. ... I have a vrt ... I hope this helps.... Take of that little door on the front. Have a ...

The normal cause of leaking while it is filling is a leaking Inlet hose. Try pulling the washing machine away from the wall and watch the hoses as the machine fills. If it is leaking you can see which hose is leaking. You may either need new tighner clips or to replace the hoses depending on how bad they are leaking. Another possibility is the water pump inside the washing machine could be broken and spewing out water.

Washing Machine Leaking From Bottom - YouTube

? 2:39
www.youtube.com/watch?v=R8ciiEeDFhQ
Sep 4, 2012 - Uploaded by Repair.com A leak from the bottom of a washing machine means a problem with ... on the carpet and stomp on them to ...

check pump

Hello Harlan;

My name is Peter. I am a retired field service appliance technician.

Your drain hose is in the back on the right hand side. This is a rubber hose. After a time the rubber may be dry rotted and leak or become partly clogged with soap residue.

Once completing the wash cycle the soapy water may have not completely drained due to a partly clogged drain hose by the time the rinse cycle is complete flooding the washer drain pan.

You do not have water in the bottom of the washer because your pump removed it all, but at a slower rate

Ok, Lets fix this ourselves:

1.) On the bottom right front of your washed is a leveling leg.
turn the leveling leg one full turn clockwise. The right front may be pitched down, causing the drain pan level on this corner to be high. Your washer through vibration may have moved slightly. This is not going to solve the problem.

2.) Pull your washing machine out so you can see the drain hose. Run some laundry on heavy load. Observe to see if your drain hose is leaking. Your hose clamps may be loose and require tightening. If it is leaking it needs to be replaced.

3.) Even if your drain hose is not leaking it must be obstructed, flooding the bottom of your unit. This is easily replaced.

The part number for your drain hose is DC97-12534D. It cast about $24.00.

Sometimes, what may seem like a washing machine leaking from bottom locations is actually one that leaks slowly from other spots. Slow leaks can accumulate beneath your washing machine making it seem like you have a bottom leak. For more help identifying the exact point of the leak, see Washing machine leaking.

Bottom leaks may be better identified using a newspaper. Just dry the floor and lay the newspaper beneath the washing machine before you test for leaks. Darkened sections map out your water leak. This method is not always foolproof, however. The best diagnosis will come from a qualified service professional inspecting your machine.

If your washing machine is leaking from bottom in the rear, you may need a replacement pump and professional installation. The leak could also be caused by a faulty air dome seal or a hole in the tub. For more troubleshooting steps to tackle that leak, see Washing machine leaking from bottom. I hope that helps!

hi there,
possible leaks can came from mehcanical shaft seal,of agitator shaft and pulley.if worn out
water leak on bottom of machine.
also on water pump inside machine,there is
also mechanical shaft seal within pulley and shaft of impeller blade.worn out also can cause leak at bottom.
maybe on inlet valve of hot and cold water
improper mounting or loosen lock cap on valve
leak can appear.
replacement of shaft seal are lots of work to do in pulling this out,but can be repair depend now on you.how you do it,this should be done by washing machine technician.have a nice day.don;t forget to rate me.thanks a lot

hi my name is joyce

Sounds like your pump is leaking. if it is leaking when you are on a spin cycle.
now if it is stuck on f1 cycle and wont drain unplug and let stay unpluged for 60 seconds and replug and see if you can restart on drain and spin cycle. let me know if I can help with any other problems.
thanks
joyce

Hi my name is joyce
Yes you can fix this yourself but you really need to let a specialist do this so you know that it is done so it wont leak. it may costly at first but it will be worth it.
if you want to do it yourself go online and type in hiya.com and go to their website and type in your model # and get your ser# and then call your local dealer in your area that deals in washers of that sort and order part and go to work.. good luck..
thanks
let me know how it turns out and please remember to rate me
joyce

Welcome bcarro10'

You said,
My Bendix washing machine doesn't fill with water instead it leaks out the bottom. I'm not sure if a connection is loose, a hose cracked or a part missing.


My name is Huuum,

I'm not sure if you search more you will, find a connection is loose, a hose cracked or a part leaking and needs replacement! As you surmised.
Or if you do not do it your self, then service will find the same!

Let me know the location of the leak when you locate it!
Cheers, and Bless You!
Please remember to leave a rating when you finish!
Thank You.Huuum