I rented a thermax steam cleaner it didnt come with instructions, where is the solution tank

To remove the dirty water tank on a Regina Steam 7.0, follow these general steps:

1. Turn off the steam cleaner and unplug it from the power source for safety.
2. Locate the dirty water tank, which is usually at the back or bottom of the steam cleaner.
3. Check for any locking mechanisms or latches that secure the tank in place.
4. Release the locking mechanism or unlatch the tank to remove it from the steam cleaner.
5. Gently pull the tank out of its slot or compartment, being careful not to spill any dirty water.
6. Empty the dirty water from the tank into a sink or drain.
7. Rinse the tank with clean water to remove any remaining dirt or debris.
8. Once the tank is clean and dry, place it back into its slot or compartment in the steam cleaner.
9. Ensure the tank is securely locked or latched in place before using the steam cleaner again.

Not sure but maybe this...

https://thermaxvac.com/products/gasket-seal-3pc-set-lid-rec-tank-05-233-03

from this site...
https://thermaxvac.com/t/main-unit-af-2

Hopefully this helps.

Best to you.

Hello, Sandra -

Without knowing the model of your Hoover steam cleaner, I believe you will find these instructions helpful:
https://www.clean-smarter.net/fix-blocked-steamer/

Best wishes.

see the causes and proceed with common sense. and fix it. God bless you
If the spray function has quit working on the carpet cleaner, check to make sure there is a full tank of water. If the water level is adequate, check the position of the gasket on the bottom of the water tank assembly. The gasket can become lodged, damaged, or removed. If this has happened, fix the gasket to the proper position according to the user manual, or replace the damaged or missing gasket.

2 Change the belt on a steam cleaner that has inoperable brushes. From time to time, belts on carpet steam cleaners become worn, and you must replace them. If the brushes on your unit have stop moving or do not turn on, you may have a damaged belt.
Replace a belt at home easily with little expense. Refer to your user's manual for replacement instructions and the part number for purchasing the belt. Remove and replace the belt according to the model of steam cleaner you own. Purchase a new belt at home improvement stores or directly

You can call for a replacement manual toll free at 877-248-9191

E-mail me for the parts manual ([email protected])then do the following.

Go to figure 3.1 and clean the filter if necessary. Goto figure 3.8 and make sure pate E is clear. Make sure the part isslides up against when inserted downward is clear. Go to figure 3.11.The slotted holes in the recovery tank lid must be clear. Finally therecovery tank lid must fit snugly and air tight. I hope this works

I have a hoover steam cleaner (f5835)didnt get instruction-I tried to use it with water(hot) and cleaner- >>when I finished nothing in the bottom- I did use water and cleaner??what I did do wrong? Could I get manual- I thought I had it in the box- but it instruction how to put it together Betty Smith- [email protected]

kindly please wait...

Check and see if there is a blockage.