Question about Radio Communications

1 Answer

Can a turner ssb+2 micraphone be wired to a ranger 2995dx cb radio?

Posted by Sherman Thames on

Ad

1 Answer

Randy Brumback

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 39 Answers

If I remember right those mics were for relay switching radios and not transistor switching radios like todays models. Also I would bet you would be very disappointed with the results as the ranger radios have an excellent modulation circuit that does not need any help from a power mic. A trustworthy radio shop tech can tune up a Ranger and make it sound excellent without a power mic. I haven't installed one in years. They are a waste of money and time in most cases except for the D104 which can be used with some base stations.

Posted on Nov 17, 2013

Ad

1 Related Answer

wood butcher

  • 32 Answers

SOURCE: wiring my turner super sidekick to my galaxy

1-shield
2-white
3-black
4-red

Posted on Feb 02, 2009

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I wire a Turner Plus Three mic to a Sears SSB Roadtalker 40 base radio?


Hello, We need the model # of the radio to tell you any info but here is the link to the Turner wiring manual. Sears radios are on pg. 21.

http://www.cbtricks.com/mic_manuals/turner/turner_mic_wiring_book.pdf

Sep 06, 2015 | Radio Communications

1 Answer

Wire 4 pin Turner Plus 3 Power Mic for cb radio to 5 pin President Washington SSB AM Radio


the best i can find is this
red pin 5 ptt
black pin 4 ptt ground
white pin 1 mic
shield pin 2 mic ground
no connection pic 3

Jan 19, 2015 | Radio Communications

1 Answer

How do i wire a 4 pin wire turner 350 hand mic to a cobra 5 pin radio


hi the easiest solution i find is to keep the ptt pressed remove wires from connector ,then place connector in radio try two wires at a time you will finally get the transmit wires then all you need is the audio ,you can flick over to ssb to sort the audio hope this helps you goodluck

Feb 04, 2011 | Magnum DeltaForce CB Radio

1 Answer

Bought a used RCI-2995DX CB and no owners manual how can I get one


Ranger Parts and Service is in California. (760) 440-0125

Dec 14, 2010 | Ranger RCI-2995DX Base Scanner

1 Answer

Squeals when keyed up. Detecting talk back.


ITS JUST NOT THE TURNER MIC IT HAPPENS WITH ALL BASE MICS HAVE HAD THE SAME PROBLEM WITH MY 2995DX WITH A ASTATIC D-104 & 1104-C AND ALSO ANY TURNER I HAVE USED BUT I CAN RUN A ASTATIC MOBILE D-104M6B OR RED DEVIL AND NO SQUEAL HAVE YOU TRIED GROUNDING THE CASE OF THE RADIO IT IS RF FEED BACK SQUEAL SO MY SUGGESTION TO YOU IS TO RUN A 48 COPPER GROUND ROD INTO THE GROUND AND RUN A NICE GROUND WIRE TO THE BACK OR THE CHASIS OF THE RADIO AND IF YOU ARE USING ANY EXTERNAL AMPLIFIERS ALSO GROUND THEM AND YOUR SQUEAL WILL BE ILLMINATED

Jan 17, 2009 | Ranger RCI-2995DX Base Scanner

2 Answers

My ranger 2950 will receive but will not transmit, also where can i get a 6 pin mike for this same radio ?


check tr 51 (Q 51) the sb754 on the back side mounting of the radio.. the center pin (collector) of this modulator ic should not be 13 volts. my bet is that it is.. this test is done in am mode.. not sideband.
depending on you carrier setiing it should be between 3 -8 volts any higher in am mode and my bet is that its bad... much more common than the finals in this radio. good luck Rick

Dec 13, 2008 | Cobra 148 GTL 120-Channels Base CB Radio

1 Answer

Will not stay on 11 meter turn it off comes back on 10&12 meter will not transmit am or ssb recieve ok. rci 2995dx.


Hello janetsue, If this radio has the blue or green screen LCD face then this is a default that is built into the radio. It depends on how the radio was "converted" when it was bought new.
It will not key up on 10 or 12 because of the default. A little more info supplied would be real helpful,,,, Let me know, Mechanic

Nov 01, 2008 | Ranger RCI-2995DX Base Scanner

6 Answers

Cb mic wiring


I have a browning golden eagle mark II. It has a two pin mic plug. I would like to hook up a astatic power mic to it. Anyone have an answer?

Oct 07, 2008 | Magnum DeltaForce CB Radio

Not finding what you are looking for?
Radio Communications Logo

Related Topics:

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top Radio Communications Experts

eradiostore
eradiostore

Level 3 Expert

1658 Answers

Brad Brown

Level 3 Expert

18520 Answers

Tom Chichester

Level 3 Expert

60292 Answers

Are you a Radio Communication Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...