I am trying to set up zoom x6 modem/router to my computer and i cant find the vci/vpi and i dont know the the encapsulation for my isp. anyone know where i can find this?

The VPI and VCI settings are made in the DSL modem, NOT the Linksys router.

Your Provider modem provides this info.

VPI and VCI codes are for broadband ADSL connections check this page out to see the numbers you need to set up, you also have to configure the encapsulation type according to your country's service, the encapsulation type is usually in the same settings page where the VCI and VPI settings are.

f you don't know the system password for the twowire it has a factory reset button near the lan ports

* Hold down the reset button on the back for 30+ seconds.

* Upon releasing the reset button, the router resets itself to factory settings.
* Connect a computer to the 2700HG-B and browse to the URL http://192.168.1.254/
* Enter a new password, confirm it and enter a password hint at the bottom of the page, in case you forget the password.

* At this stage you might receive a "Page Not Found" error, but the password appears to be set successfully.
* ***************************
* To continue, manually browse to the url http://192.168.1.254

* Home Page (summary)
* Run System Setup Wizard

* Enter key code 5225 2374 WG62 22AS BJ7P (from http://www.2wire.com/?p=268) to set up manual config

-> Next

Choose TIme Zone -> Next
* Enter ISP set up details

* For most UK ISPs this will be
Connection type = PPPoA
VPI = 0
VCI = 38
ATM Encapsulation = VC-Mux

**********************

For Be /O2 users only

VPI = 0
VCI = 101
ATM Encapsulation = LLC
Exit Registration when connected to Internet
***********************

If this helps you plese rate and vote

Hi,

You dont need a setup CD as this is a router. you should have the manual which will explain in detail the process of installation. If you dont have the Manual as well, then provide the below details and i can help you fruther on this

Name of the ISP:
VPI / VCI value (to be collected from ISP):
Total number of Wired computer/s:
Total number of Wireless Computer/s:
Operatins System used on computers:

ayamaya is says correctly.

Well for most zoom X6 routers I saw it's

http://10.0.0.2

That should take you to the main page. The manual is located here for X6 models.

http://www.zoom.com/techsupport/adsl/adsl_x6.shtml

In the manual it's on page 13. I would download a copy of the manual and read it as well.

Try this site: http://www.spiritone.com/support/dsl_zoomx6_wireless.html

Does Big Pond and your new ISP dodo use the same values for VPI/VCI?

If not, you need the correct VPI/VCI for your new ISP.

Read the FAQ at DSL Reports on the 5260 and changing the VPI/VCI using EnterNet 300 1.5b or EnterNet 300 1.5c.

http://www.dslreports.com/faq/15476

Regards,

Doctor Olds

Hi Maybe i could help you. I have installed this modem before for an ISP provider. Please give me specific task you want to do and I will explain what to do.