Wcvh6800j1ww door will not lock - GE WJSR2070B Top Load Washer

http://www.appliancepartspros.com/ge-hinge-door-we01x10233-ap3994875.html


http://www.repairclinic.com/PartDetail/Door-Hinge/WE01X10233/1264184

You have a faulty door lock that needs to be replaced. Here is that part to order.

You may view/download the manual here.

Three screws at the back of cover, three screws at the front, push the cover back and you can remove it. 1 screw at the front of the soap drawer and two more on the dispenser and you can lift the whole unit up.

see the causes and remedies:
It spins, but doesn't pump
drain lines clogged, repair+sock in outer tub port, if the lines is not clogge the problem is pump replace
It doesn't spin or pump
frozen pulley pump, replace
It pumps, but the water returns improve the draininin laundry, if have reaches 4 inches cut off the excess. if is lower install air/gap siphon break assembly.
God bless you

Try to clean the discharge pump filter first (Instructions on page 13 of the Use/Care manual).

If the drain pump is working, it's most likely related to the pressure switch. Check out these postings:

http://www.fixya.com/support/t9807344-ge_front_load_washer_stops_45_min_35_min http://www.fixya.com/support/t8933273-general_electirc_washer_model Do a diagnostic test -- Easy and free, and the machine will likely diagnose its own problem. Instructions in those postings.

Post back any code you find and we'll go from there.

Hello,

the only way to do a reset on this unit is to unplug while powered on, let me know how it goes,

http://www.appliancerepairlesson.com/

if this washer has a control board on top of motor try opening the lid six times within 6 seconds... then start washer .... if it does have board ontop of motor look at board is green indicator lit up if not replace fuse link white wire with red line threw it from motor has a one time fuse link in wire replace fuse link or jump across to test

need same solution, please post