My adora range does not work after an outage. The indicator light comes on but it does not work

Hey Scott, I understand that you are having problems with your Electrolux Dual-fuel Range. When the range is first plugged in, or when the power supply to the range has been interrupted, the indicator lights will flash and the control will beep. To stop the lights from flashing, turn the selector control knob to BAKE and back to OFF. You can also attempt a hard reset by unplugging or turning the household power breaker off to the appliance for five to ten minutes. If the problem persists, please reach out to a professional technician. Hope this helps! -JK

Sounds like a board gone.

turn it off and disconnect all the electric. DO NOT mess with the gas. call a technician. Safety first.

I need correct part numbers for GE Adora model JGBP87SEL2S LP to NG conversion

i need the correct part numbers to convert a GE Adora model JGBP87SEL2SS from LP to NG,

after power outages it is common for electronics to blow aftere the intial surge when power returns.. i would bet ur control board is blown..i would check that out for any obvious signs of damage

If the bake ignitor comes on (starts glowing after a few seconds) - check the amperage on the bake ignitor wires when it's on. If the ignitor is a round style - amperage should be 2.5-3A, if the ignitor is rectangular - 3 - 3.6A. If less than 2.5A or 3A respectively - replace ignitor.
Ignitor part numbers for round style ones: 4342528, WB2X9154, SGR403, 5304401265;
rectangular styles: 12400035, WB13K21, WB2X9998, SGR412, NR020, 5303935066, 814269, 9753108.
Ignitors of the same shape (i.e. rectangular) are interchangeable, if you can splice the wires.

Good luck!

try pushing cook and hold button once until lock comes on, then push cook and hold button again. The lock should be removed.

may be a simple glow plug problem, will need more info to determine for sure.

part number for the griddle is WB31K10140
partstore.com has it for $87.95 hope it helps