My problem is/ i have machine paxar 9855 bat i haven't driver plz you can envoyer thanx

print speed of 152.4 mm/s and a resolution of 203 dpi

Here is the link to the 9855 operator's manual. Page 101 of 132 shows you how to replace the printhead. It's a pretty simple procedure.



http://www.monarch.averydennison.com/support/servdocuments/User_Documentation/9855/9855oh_ag.pdf

you need to have the printhead replaced.

do print test by pressing both arrow buttons at the same time and the unit will do a print test. look for the line BAD DOTS and if the Value is greater than 000 the printhead needs replacing

To buy a Paxar Monarch 9855 you can buy it to the nearest appliance center or any electronic center in your place. If you can not see that in your place you can buy it through online. Visit and inquire it in ebay or amazon website.

www.ebay.com or www.amazon.com

Thanks and good luck!

ICman

Perform an internal diagnostics test print. I believe you can press both of the arrow buttons at the same time, and it should print out what's in the printer and how its configured. There you should find the firmware version.

Your software wouldn't care whether it's a 9835 or a 9855. It can't even tell the difference. Are your supply settings and communications settings the same for both printers? Any error messages on the display when you print?

You have a format problem. Something isn't correct in your mpcl code.
Error 400 - "The character immediately following { is invalid or not an ASCII character."

sir,

Click this link for driver.....

http://www.paxar.com/support/service_utilities.html#WindowDrivers


Click the link and below they have the list of driver. Download it....


thanks
good luck

My brother dcp tells me
unable to print check troubleshooing and maintenance chapters.
I have done this and cleaned the printer, it also tells me ink jets empty, they are all new ones.
Driving me mad any suggestions so I can get my sanity back.

Thanks
Denise

Your 287 error has to do with an incorrect setting for printhead width, and in the control language that your software is sending to the printer, they either have something other than 0, or there is an invalid character like a carriage return or line feed being sent to the printer.

This is a difficult one to trace since the software sends the code and you cannot necessarily change what is being sent.

Please note that the software that you really should be using is PC Mate Plus, as this is a specialized printer for Paxar supplies called Care Labels. You may be able to cheat if your software allows you to select 300DPI print heads. If not, you'll need the software I suggest.

If you do not have this software, please contact Paxar (now Avery Dennison) at 1-800-543-6650 and ask to be connected to someone in technical support or if the customer service rep can offer you a link to a website for software download, or purchase.

Ohiotech