Sewing manual Where could I get the sewing manual for the Janome Sewist 625e sewing machine?

have you applied any lubricant to the bobbin holder the one that holds the bobbin? I would suggest using your manual and lube your machine. sounds to me like your mechanism is sticking.

Look on machine for little red dots with a small hole nearby. Usually these are near the threading points and also on the foot near or on the metal flap. Also they may be under the flap near the bobbin. Make sure you wipe the excess oil off before using.

try these 2 sites for a manual
sewvacdoctor.com
a1sewingmachines.com

Are you talking about feet or bobbins? Did you buy the machine new? Do you have a manual?
In my experience of this type of machine, the bobbins were plastic

Check that the bobbin winder on top of the machine is clicked to the left or disengaged.

More than likely. You mount the walking in place of the regular foot. You just have to attach the fork over the needle clamp screw at the same time.

Hi
I looked on the Janome site and couldn't find a manual for this model, even in their retired machines section!
Looking at the picture above, I think your machine is most like the 521. Here's a link to a partial manual for the 521 from the Janome site.
http://www.janome.com/documents/File/ManualFile/Sewist521.pdf
If it is not similar enough to your machine, go to the Janome homepage at www.janome.com and use the drop down menu marked machines. Browse through the various categories of machine until you come to one that most resembles your machine. Click on the link for that machine and then click on specifiaction and you should see a pdf icon and a download manual button to download a manual for your chosen machine. Hope this helps!

Hi. It may be that you need to adjust the tension. Put a different color thread on top than is in the bobbin and sew a couple of inches, then check. I suspect you'll find that the top thread is the one that is loose and knotting up. (It's hard to tell unless you're using two different color threads.) If that's the case, your upper tension needs to be tighter. Tighten it just a bit, then sew a few more inches and check again. Repeat until you don't see any of the top thread on the bottom (or maybe just a little bit) or the bobbin thread on the top (or maybe just a little bit.).

Hope this helps!

Robbie

google search and put in "manual for (sewing machine #)" and you will get to download manual. It will take you to several websites that have the manual to download. I did it for mine. I have done it for several other things like cameras, etc.

how to thread a janome model 372