1000 suply error - Office Equipment & Supplies

Shop for Televisions Power supply on Google

SoundPoint IP 24V Universal...
$9.99
Google Trusted StoreMetroline... EVGA 120?G1?1000...
$139.99
Google Trusted StoreNewegg.c...

(28) Thermaltake ? Tr2?600nl2nc...
$44.99
Best Buy
In store Rosewill Stallion Series...
$39.99
Google Trusted StoreNewegg.c...

(406) 1000W Power Supply
$155.99
Google Trusted StoreNewegg.c...

(58) Search Results

Power Supply Boards - TV Parts - ShopJimmy

the Error code was sited below as the (Disk Self Test) DST Log contains previous error(s)

in case of your error DST log contains previous error(s) doing a chkdsk /r or a repair reinstall of xp might resolve the issue.
to resolve issue...


Error Code Error Message 1000-0141
or
2000-0141 No Drive Detected 1000-0142
or
2000-0142 Drive Self Test Failed Status Byte=XXh 1000-0143
or
2000-0143 Drive Smart Read Command Failed 1000-0144
or
2000-0144 No Support for Drive Self Test Error Code Error Message 1000-0145
or
2000-0145 Timeout waiting for Drive Self Test to complete 1000-0146
or
2000-0146 DST Log contains previous error(s) 1000-0147
or
2000-0147 Unit (x): IDE status failed. Status byte = (x) Control Code = (x) Msg = (s) 1000-0148
or
2000-0148 IDE ERROR: status (x) (s)

wath kind of power connetions ?
round 6 mm outsite negative insite positive (12 volts)
if yes you buy power suply wit at minimum output over 1000 mA how more are better

remove the bios battery for 20- 25 mins.small flat round battery on the motherboard then put it back in. start up computer

You can consult the manual.

http://h10032.www1.hp.com/ctg/Manual/bpu80012.pdf

change the composite power suply board

The error code tyo which you refer was truncated off of your posting. Could you please enter that code again? That code will assist us in determining the problem circuit.

Thanks,
Dan

10.00 error is for the black cartridge. Check the cartridge locker for the black toner cartridge on the right side, is it different from the other? does it moves correctly? check properly. If the locker seems correct, try clean the contacts on toner and opposite HV pins in printer

i have the same boiler and this code refers to gays suply error, i would suggest a engineer to yake a look at it but first check if ur gas suply is ON ...!

I have to assume that your post is some question concerning the SMPS on the Akai TV and then further assume that you're dealing with a dead condition??? That given, you probably need to replace several caps on the SMPS that can be ordered as a kit. The kit supplies 19 caps in-all (4) 3300/35v, (8) 2200/25v, (6) 1000/10v and (1) 1000/16v the last seven 1000uf caps can all be 16v if you order the smaller style.
That is assuming you are experiencing a dead condition on your set. It is best if you can give a tech a little more to go on than "power suply" if you're actually wanting any real help.
Bill