My machine isnt stitiching after I heard a pop inside the machine while I was sewing. I titled it several ways to get the pieces that I heard tumbling around inside and I found out wheere they bellong but I don't see the correlation of those peices and why it is not stitching. It still rotates and the needle still goes up and down. what could I do to fix it if it has anything to do with those peices and I have pictures too, hopefully they will appear along with this post. Well the picture cannot be uploaded on here but if you would like to see them pleaase help me find a way to get them to whoever will be able to solve this issue. Quick FYI this machine is only a week old.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
it depends on the name brand of the machine, call some sewing machine repair shops tell them what it doing and ask about repair prices and then decide what to do .
Wife says it will likely have to be repaired by a machine specialist in your area. Sometimes when that happens, the time gets off and needs to be repaired. It works when you turn it because your going much slower than the speed the foot pedal goes.
Top tension about 4 or 5, pull the bobbin thread through so there is slight resistence, if it is too tight, slacken the screw on the bobbin case about a quarter of a tuen anti clockwise and test and keep doing it until you get it right
The belt may have come off or may be slipping and the only way to check is to get inside the machine which will be very difficult if your machine has a two piece body
not sure which model you have but you should have a stitch length control and a stitch width control. locate the stitch width control and set it to zero.
if you have done this and the machine continues to zig zag the zig zag mechanism inside the machine is most likely seized up. try lubricating all linkages inside and move the control lever a few times to see if it will free up.
if not you may need a tech to service the machine.
Sounds like the bobbin thread is not inside the tension on the bobbin case. This normally happens when the bobbin is upside down. Insert the bobbin and pull on the thread.The bobbin should turn counter clockwise. sewman7
Okay, I know that you are an experienced sewer and have probably already checked, this but I had the same exact problem today and cleaning the shuttle race fixed it.
×