My letters are not lined up after reinstalling the print wheel

Remove the print wheel and wash with soap and water. Turn the typewriter off and reinstall the print wheel,

The print hammer is striking between the letters. Two thing
you may have a petal, letter broken off. If its the same letter every time usually thats it, need new daisy wheel.
Or Homing is off when the wheel turns hammer hits between letters. Needs repair.
Or
Daisy wheel petals are bent.

Most likely one or more of the spokes is bent on the print wheel. Remove the wheel and turn it by hand you can usually straighten them. The vertical lines are from the face of the hammer when it misses the letter.

DickyO

Hi!

Try to reinstall the software driver of your printer.

Hope this helps.

The lines are the hammer face you have a bad printwheel.

DickyO

When you print only two vertical lines either the capitol letter S is missing from the print wheel or is bent out of range of the print hammer

The Daisy wheel is probably in wrong..reinstall it until it spins to the home position. Its either that or an adjustment to the print wheel motor.

From Printers and Faxes, delete the Stylus R300 icon. Restart your PC and reinstall the Stylus driver. Good luck.

turn the power off. Remove the ribbon and print wheel & corr tape. turn the power on close cover let it home. open cover install the print wheel & ribbon try typing. if works reinstall the corr. tape. if not there will be a switch with 10.12.maybe 15 or PS make sher the pitch is in the same number as the print wheel. hope this works. C.W.H.

there is a slide switch on the L.H. side of the key board that reads 10,12,15, PS
the switch needs to match the print wheel stile you have in your typewriter. most typ's have 10 or 12.
PS stands for proportional spacing a takes a spicule print wheel