Question about Frigidaire Washing Machines
I don't think a coin could travel to that point-Icould be wrong but regardless its time to roll up the sleeves get some old towels to wipe up the mess and dig in and see whats going on in there-cheers Denny
Posted on Oct 24, 2013
Possible that you would have a tub seal leak if it is only noticable during spin cycle. Possible that it "drips" slightly while in agitation, but not enough to notice it. While in spin mode you have a lot more parts moving as well as a lot more water pressure on the seal itself. Pump could also be leaking, but highly doubtful since it would leak a constant amount at all times. Good Luck!!! Jim
Posted on Sep 09, 2007
hi without further investigation its a bit hit or miss , does the whole tub tilt or is it just the inner drum ?
if its just the inner drum then it sounds like the bearings are on there way out
if its the whole tub then it could be one of the springs that it hangs from or the shock absorber underneath that may have come adrift
hope this helps
Posted on Jan 30, 2008
SOURCE: washer makes loud knocking noise
HI thanks for your question. you could have something stuck in one of the holes, in the tub, or something caught in the pump, check those 2 . if need more assistance , get back to me. thanks the appliance doc
Posted on Oct 11, 2008
old duets have nut on rear pulley that becomes loose. remove rear panel and tighten nut. check while spinning by hand if pop is felt. if it rotates smoothly then you may need new shocks on tub
Posted on Mar 14, 2009
SOURCE: Walking during the spin cycle
My GE front load washer model WCVH6800JBB have the same problem. I just purchased and installed it yesterday, 05/04/09. Just like everyone said... when it got to the spinning cycle it walked to the middle of my garage and all the connections in the back of the machine fell off. My husband checked the instruction... There are 4 nut bolts in the back of the machine near the rubber leg (level). You need to take them off and try to balance your machine again. My washer is running very smooth now. Good luck!
Posted on May 05, 2009
Tips for a great answer:
Mar 04, 2016 | Washing Machines
Apr 01, 2013 | Maytag Bravos MTW6600T Top Load Washer
Mar 10, 2013 | Haier RWT350AW Top Load Washer, White, 3.0...
Jan 30, 2013 | GE WHRE5550K Top Load Washer
Aug 21, 2012 | Maytag Neptune MAH5500B Front Load Washer
Jan 14, 2011 | Haier HLP23E Top Load Washer
Apr 21, 2010 | Whirlpool WTW5200S Top Load Washer
Apr 10, 2010 | GE WJSR2070B Top Load Washer
Oct 18, 2009 | Kenmore Washing Machines
Aug 28, 2008 | GE Washing Machines
65 people viewed this question
Usually answered in minutes!