Canon mf6530 system error code e0000

that is the laser cannot be detect.
if you can to do...
check all cable which connect to laser, perhaps there are just loosen.
but if it was look well. you must replace a new.

erreur system e000 canon ir 1510

E-007 is an error in the fixing film assembly. Usually torn or rotating incorrectly. There was an update to the material used to make the belt. Old color tan, new color black. This error code will require a service by a Canon service Technician.

Write the model of your machine. If this Canon, that this cross point fault of the fastening, lamp of the heating faulty if this Minolta, does not come to motion main engine, write your model. In any event, I am run away that fault under code E0000 deal of the skilled personnel of the service service, and requires change device, do not lose time. Good luck.

it could be the fixing/fuser heater is not working ,check heater lamp or thermal fuse/switch this error indicates fixing unit problem

...usually the problem is in the fixing unit...

E0000-0132

the cause of error is the fixing heater/s is not functioning well .Try this press asterisk with the head then 2 and 8 simultaneously then same asterisk with head. The lcd display will change Pres the ff: COPIER>Function>Clear>Err > ok .to reset fixing error .Switch power off and on the machine.If the Error
return, you have to call the canon service agent to check your fixing/fusing unit and its components

regards

this is the fixing error indication reset it * 2 & 8 simultaneously * Copier>Function> Clear>Err>OK .Restart the Machine

this err belongs to sensor problem.
chech thermostat sensor

Try this one from Canon's website:
Issue: ERROR LCD: System Error E000
Solution: Reset the unit-IC D/PC 1000 Series

Reset the unit

1. Slide the platen to the left.
   
   
2. Slide the platen back to the right until it locks in place.