POCKET CAM DISPLAYS 'CARD ERROR'

Try to re format card in camera

Look at your memory card. SD and SDHC cards have a slide switch along one edge. The position farthest from the metal contacts locks the card, protecting it from writes. The position nearest the contacts unlocks the card.

The best thing would be to borrow a laptop or PC with a card slot, and format it there.
If it continues to show error when formatting, the card is defective and should be replaced. (Returned?)
Out of 5 memory devices I have bought in last 3 years, 2 came with a free virus. This from reputable stores. Be sure PC has antivirus installed.

It is not at all unusual these days to find NEW memory devices that don't work. Production methods are cheap as they can be. Just return it for refund or exchange.

can mean that the memory card is locked. take out the memory card and check for a lock slide at the sides of the card that you can adjust to a lock and unlock position, then test the card again.

Hi there, I suggest you replace your battery. Because after charging it will showing full but it is not real. Because you using in last 3 - 4 years and thats why the life of battery is finished. If you changed the battery already then remove the memory card and try to on the camera. If that time its working well then replace the memory card. Thanks & hope its helpfull.

Did you try formating the memort stick.
This will clean up any error in the stick.
Don't let the battery in the camera run to low, messes with the flash memory.

Check the lever on the SD-
Try an alt. card reader.

It sounds like your SD card is faulty.

Contact KODAK:
http://www.kodak.com/eknec/PageQuerier.jhtml?pq-path=14563&pq-locale=en_US&_requestid=3490

Try booting in safe mode and try system restore, by clicking on start>All prog>accessiories>system tools>system restore. and restore the system to an earlier time when it was working fine.

This can be due to various reasons
1)The driver is corrupted: The camera's drivermay be corrupted. Uninstall the driver and any software and then connect the camera to the PC and then re-install the software.
OR
2)The USB cable might be faulty. Remove the memory card from the cam and try using a USB card reader(You can get one for 5$) and see if works. If it does may be then its time to buy a new USB cable for your cam.
3)Last but not least the cam's firware may been corrupted. Its pretty easy to flash the firmware so we can try it. Let me know if the above solutions worked or not so that we can try the firmware update

i think you have broken or bended any of the pin inside the card slot, and that is creating problem. Try looking in the card slot you may find any of the connector pin broken or bended. Try straighten the pin cautiously and may your machine start working .