Where do i charge my rca m4018a at it has no spot to plug it into just a headphone part

Ron, yes the base is the charger, links below show info.

RCA Cordless Headphones WHP141

http://voxrightnow.custhelp.com/app/answers/detail/a_id/7770/~/features-and-functions-of-the-rca-whp141-wireless-headphones


Follow up Review of the RCA 900mhz Wireless Headphones

Top 5 Wireless Headphones Review The BEST Wireless Headphones for 2014

Adjust the tuning wheel on the side of the headphones so it picks it up.

Instructions
1
Set up the transmitter. Wireless headphones rely on a transmitter that sends audio via infrared or radio waves to your headset. Use the digital audio output (coaxial or optical), RCA outputs (red and white) or headphone jack on your TV to connect the transmitter. The connection will depend upon which outputs are available on your TV and/or the transmitter.
2
Use an RCA-to-headphone adapter. If you don't have a headphone jack on your TV and the transmitter includes only a headphone connection, connect an RCA-to-female headphone connector. This will allow you to plug the wireless transmitter into the female headphone end and then hook the RCA ends into your television's audio outputs. You may also need a 3.5 mm (mini jack)-to-1/4-inch adapter if the headphone plug on the transmitter doesn't match the television jack.
Read more : http://www.ehow.com/how_4883556_use-wireless-headphones-tv.html
3
Set the transmitter on top of, or next to, the television. For infrared transmitters, you'll need a direct path between the headphones and the transmitter. Placing the transmitter on or near the TV will allow you to take advantage of the clear path you already have.
4
Plug in the transmitter and turn it on. Charge the headphones if necessary.
5
Turn on the headphones. Adjust the volume and settings and you're ready to watch TV.
Read more : http://www.ehow.com/how_4883556_use-wireless-headphones-tv.html

good luck

Using a headphone to RCA adaptor plug the headphone jack into the headphone connector of the Ipod. Then plug the RCA jacks into any available Analogue input on the receiver. Increase the volume on the Ipod to 80% then adjust the receiver's volume according.

Or get a dock that will allow remote control and charging, such as Roth, DLO or Wadia.

BATTERY INSTALLATION AND INFORMATION
Your wireless headphone unit requires two rechargeable AAA batteries.
Rechargeable batteries are uncharged when you purchase them. Before
you can use the wireless headphones, the batteries must be charged for
16 hours. Follow these steps to install and charge the batteries.
Installing the Rechargeable Batteries
Take care to follow these steps to correctly install the batteries.
1. On the right headphone, locate the battery compartment (1).
Use the finger depression on the compartment to turn the battery
compartment cover counterclockwise to remove the cover.
2. Insert two AAA rechargeable batteries, carefully following the
markings inside to ensure the batteries are inserted properly, with
the + and - ends in the correct positions.
3. Replace the battery compartment cover.
Charging the Rechargeable Batteries
To recharge the headset unit, follow the directions below. Note: The
cradle/transmitter on the WHP141 is not a recharging cradle, although
you may place the headset in the cradle during recharging.
Follow these steps to recharge the NiMH rechargeable batteries.
1. Make sure the ON/OFF switch (2), located on the right headphone,
is in the OFF position.
2. Connect the AC/DC main power adapter to the DC IN power
supply socket (11), located on the back of the cradle/transmitter.
3. Plug the adapter into an electrical outlet.
4. Connect the charging cable (10), located on the back of the
cradle/transmitter to the recharging input (3), located on the right
headphone. The headphones can either be placed in the
cradle/transmitter or placed next to the unit. If the headphones are
connected correctly, the charging LED indicator light on the
cradle/transmitter (8) illuminate.

When RCA makes the cords to charge and sync the device to the computer they used cheap parts and at the connector where you plug it into the mp3 player they don't solder the wires very well you cant repair it you nave to buya new one. VISIT LINK BELOW!!!

http://cgi.ebay.com/FOR-RCA-OPAL-M4008A-M4018A-M4002-M4004c-USB-CABLE_W0QQitemZ130291230332QQcmdZViewItemQQimsxZ20090304?IMSfp=TL090304122004r35488

Hey,

You can go to Wal Mart and buy a universal car charger for

under $5 and it will work on computer to charge as well as

in the car.

Try going to rca's website and doing a firmware update to the mp3 player.

MAYBE YOU SHOULD CHECK TO SEE IF IT'S ON HOLD BECAUSE MINE USED TO DO IT AND IT WAS ON HOLD.