Put in new batteries and scooter does not move fwd or rev

Is the charger plugged in to the mains?
If not, do that and it should fix the problem
The scooter engine my need to run to charge the batteries. So do it on the driveway or in the backgarden.

bad tranny,have it checked

Has the brake lever been put in the freewheel mode?!

I had a similar problem on my Pride Legend scooter, it would
creep back in reverse if you let go of the throttle. The FWD/REV spring tensioned throttle pot inside was "off center"causing it to activate in reverse when it should have stayed put with the electric brake energized.
I had to replace the throttle pot assembly. Not sure if yours
is similar, but I would suspect it might be.

Could be the Throttle Pot or Speed Pot. The levers will change the resistance of the throttle pot. The speed pot feeds the throttle pot.
Move the speed pot while pushing the lever forward. If it works could be the speed pot has a dead spot on it. Also check wires loose and a mechanical issue with the throttle pot and the springs.

So the status light does not flash ? just a steady green ?,,,

so when moving the throttle lever or wig wag what ever you wish to call it , is there a click from the rear brake located on the side of the motor ???

Regards
Rob

www.gewizrepairs.co.uk

are you sure batts are connected right check if u have them hooked up 24 volt

It could that your potentiomenter is broken and would need to be replaced. simply removed the housings from both sides to get to the throttle part and check to see if the spring is not broken. if it is broken, simply remove old one and buy new one which should be around 60.00 and up in cost. can go to this website to check
http://www.monsterscooterparts.com/mobility-scooter-throttle-pot.html

well you need a new transmission for it. start looking on google or ebay. nobody here sells lawn tractor transmissions.