- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Here are the instructions from the manual for my Contour Design SURFACE SOUND COMPACT (with minor editorials)
To initiate pairing:
Place the bluetooth device and your mobile phone within 0.3 meter (1 foot) of each other - I prefer to place both on a table infront of me
Switch on your phone and select it Bluetooth discover mode (you'll have to figure this one out on your own!)
Immediately after turning the bluetooth device on (ie. lifting the microphone), press and hold both the TALK button and the VOL + button for about 5 seconds until the indicator light flashes red and blue alternately and a sound can be heard in the speaker - I had trouble getting it to co-operate once it started into the seeking handset mode of beeping, so try to press the two buttons before all that beeping starts
Once the mobile phone detects the carkit, a "contour SSC" message will be displayed. Follow the phone instructions to accept the pairing. The PIN coade (or passkey) is 0000, then press "yes" or "ok". I assume the PIN code is the same for all of them, as the manual appears mass printed.
If the pairing was successful, the indicator light will switch to blue and flash slowly. If you haven't started the discovery mode within 5 minutes, it will stop. In this case, you must start the pairing again as step 3 above.