HOW TO RESET MAYTAG DISHWASER MODEL MDBH955AWW

Check the door gasket, locking assembly for proper seal/operation.

Go here for parts Search Over 2 1 Million Appliance Parts

You may have a wire problem where the house wire hooks to the dishwaser wire.you will have to take off the bottom panel and check. Please be sure to turn off electric before removing the panel.

Hi,
Here is a tip that I wrote that will help you with your problem...

Dishwasher Problems - Water will not drain out
http://www.fixya.com/support/r4078724-dishwasher_problems_water_will_not_drain

heatman101

If the water pump inside is stuck, this will happen. Do not run unless you are clear. The pump coil may get burnt if left to hum.

Humming noise will be some times due to the the relay coil also. If you can check your self it's fine. Otherwise take the help of a service provider.

Check whether the door is getting closed fully. Try pushing little hard. If the door close switch problem it may work.

Contact service for help if u can not proceed further with electrical circuits. Micro-controller board to be checked!

you need to soak them in vinegar.this will keep hapening unless you run your kitchen fauset untill the water is hot then start your dishwaser.and use a good liquid soap like caskade compleate.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/dude_653d05454b389bba

the only thing you can do is take it to the place where they repair motors. like where they fix windings ect . im in ny so you have to check your area for one in your neighborhood. let me know if this washelpful to you

i would say it's a serious internal problem ...not a simple fix ...call for service

liberty, it sounds like your keypad is bad, here is your tech sheet for your dishwasher, it will give you detailed instructions for checking it out. Catriver
http://www.servicematters.com/maytag_library/docs/16026393.pdf

It could be the impeller on the motor. The impeller fits over the shaft of the motor and might have split/broken up. That funny noise is probably the shaft spinning inside the damage impeller. Fortunately the impeler is fairly inexpensive and easy to replace. I believe there are one or two parts/covers to remove that are held in by a roughly half dozen torx screws.