Need a part 318182734

You need to change the heat resistance controller it needs a qualified person the oven needs to come out then open the top remember to unplug first then find a coiled resistance it will lead you to the switch control this needs to come out from the front panel and inside oven hope this helps

Your failure to provide fixya experts with the needed info,i,e,;make,model,year,exactly what the nature of the problem is,can get you all kinds of answers,we deal with 1,000's of questions without the needed info on a daily basis,if you expect a good reply then give the needed info!!!

Hi,

The hinges and receivers would need to be replaced on this. The hinges are part number 71003351 you need 2, they go inside the door, so the door would need disassembled.

The receivers (hinge receptacles)are part number 71002206 you need 2 also, these go on the side of the oven. You will need to pull the oven out a few inches to gain access to these

Hello,
You will need the owner's manual to follow their LP conversion instructions. You will need the make, model and serial # in order to buy the LP conversion kit (if needed) from a local appliance parts store or from the store where you bought the appliance. Typically, you will be either adjusting (turning down) or exchanging the main burner orifice(s), as well as adjusting the air shutter on the burner venturi tube, as needed for a bluer flame. The appliance regulator will need to be converted, which is usually done by flipping the cap. If you don't have your owner's manual, leave another comment for me with the model # and I'll see if I can find it online for you. I have not worked on this particular type of oven in my neck of the woods, but ovens are all pretty similar in design. Some also have a thermostat that needs to be converted by turning the Nat to LP selector behind the temp dial. Hope that helps. Douglas

no u dont how is it going to read the temp for self clean. never heard of removing the temp probe. the things u remove are the oven racks

You just need the glass, get part number from Bosch website (UK) and source locally.

To fit just dismantle the door.

HI, this is a Element relay circuit failure. this relay is a separate PCB board with attached relays.

this relay board will need to be replaced.

CLICK HERE TO ORDER

keep all the L1 & L2 leads to the outside terminals and only the N wires go in the middle.

your unit dioes not have a pillot that would need need relighting, it instead uses a glow bar ignitor. auto pilot.

Look in yellew pages for a Zanussi dealer, you will need mod number,,serial number, and er number, all of which are on the rating plate found at the front of the oven.