Question about Onkyo Audio Players & Recorders

Have an Onkyo a/v receiver, model tx-nr809, victim of lightning strike. When power cord is plugged in I hear one click about every two seconds. No other signs of life.

Gregory Lynn Oct 02, 2013

Found a blown fuse, replaced it. Unit powers up now, but I have no audio or video output and the cooling fans are not spinning up.

1 Answer

Frank Fulton

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

President:

An expert whose answer got voted for 500 times.
Onkyo Master
1,114 Answers

Capacitors, transistors,and a couple resistors. Internal repair. A shop will charge anywhere from 100-200 depending on time and parts.

Posted on Oct 02, 2013

3 Related Answers

Anonymous

3 Answers

SOURCE: Onkyo - direct tv code for tx-ds 787

does anyone knows the code to control the onkyo TXDS 787 through the comcast.remote.?

Posted on Aug 21, 2008

Rami Obeid

16 Answers

SOURCE: Onkyo TX-SR 606 KEEPS CLICKING INSTEAD OF TURNING ON WHEN POWERED

Here are your options:

1. An electrical problem, where your receiver has a grounding problem.
2. Your speaker wire connections are actually touching each other and that's why your receiver is not turning on.

Posted on Nov 15, 2008

Anonymous

93 Answers

SOURCE: Powered Or Unpowered Subwoofers For Onkyo TX-8511

Greg- Powered subs are better than non-powered subs (also known as passive subs), anyway I see the TX-8511 has no sub pre-out on the back panel, so you need to decide what sub you will use and run from the receivers left and right speakers output into a subwoofers speaker in from speakers then back out to speakers, look at the back of a subwoofer and you will see like 4 sets of speaker hookups 2 in and 2 out, what this does is takes the low end or bass and drops the signal to the subwoofer then takes the mids and highs out to your left and right speakers, unless your regular left and right stereo speakers have large woofers a sub is the way to go.

Posted on Jan 28, 2009

Add Your Answer

Upload

Upload an image from your computer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

Loading...

Include an image. It's worth a thousand words.

prev next

Related Questions:

1 Answer

My Onkyo TX_NR809 defected Where can i buy a new hdmi board for my Onkyo TX-NR809

search the web for p/n: 1B248597-1D_TXNR809E That is the correct p/n for that hdmi board.

Feb 18, 2016 | Onkyo Audio Players & Recorders

1 Answer

My Onkyo TX_NR809 defected

Onkyo's defecting to the soviets has been a problem for years. That's why we have the CIA

If you need further help, I’m available over the phone at https://www.6ya.com/expert/gregg_27a4d257e54e7920

Feb 18, 2016 | Onkyo TX-NR809 A/V Receiver

1 Answer

Anyone have a idea where i can get a ONKYO spare part posible in the Nort wesr

Hi Ron, you can call our Parts and Service Department at 800-229-1687 they are available from Monday to Friday from 9am to 5pm est. std. time, Thanks, JT

Mar 04, 2015 | Onkyo Txnr809 Tx-nr809 Hdmi Board

1 Answer

Onyko tx nr616 receiver keeps shutting off. Only stays on for approximately 3 seconds. Can you help?

The amp protection circuit has been activated. Remove the power cord from the wall outlet immediately. Disconnect all speaker cables and input sources, and leave the AV receiver with its power cord disconnected for 1 hour. After that, reconnect the power cord and reconnect an input and a pair of speaker wires onto the unit. If the receiver still does not turn on than you will have to bring it in for service. Turn up the volume and if the receiver doesn't shut down, power off the receiver and add another pair of speakers. Power up the unit again and turn up the volume. If it doesn't shut down, power off the unit again. Now connect all your input sources and turn on your receiver. If the unit shuts down again, your unit will need to be further serviced at an authorized Onkyo service center.

Sep 30, 2014 | Onkyo Tx-nr616 7.2 Thx Certified Network...

1 Answer

TX-SR803 with no sound or popping hissing on any input

It is common for a short term power surge to open up the internal fuse in the main power transformer. Without testing some components inside the unit, I really can't say for sure whether or not the unit is worth repair. I would suggest that you invest in a detailed repair estimate at an authorized Onkyo service center.

Keep us posted.

Dan

May 26, 2009 | Onkyo TX-SR803 Receiver

1 Answer

TX-SR504 receiver won't turn on

Had same on an ONKYO TX-505 given to me for repair - eventually found a broken track on top circuit board that came from a transistor that control the main power on relay - looked like it was burnt off for a section of about 1.2mm

Repaired the track and has worked ever since

good luck WTech/Townsville

Mar 18, 2009 | Onkyo TX-SR505 Receiver

1 Answer

Onkyo TX-DS989 not staying on

This sounds like the action of some protection circuit that is monitoring some condition or voltage that isn't within its design limits. If it was mine, I'd look for an Onkyo forum to see if others have experienced the same problem.

Sep 10, 2008 | Onkyo TX-DS989 Receiver

1 Answer

Unit no longer powers up after shorting the switched plug in back of unti

you most likely fried a circuit board trace on the power supply

Dec 25, 2007 | Onkyo TX-SR500 Receiver

1 Answer

Onkyo TX-SR605 Receiver HDMI Issue

How good are the hdmi cables that you are using???

Nov 26, 2007 | Onkyo TX-SR605 Receiver

1 Answer

Onkyo TX-8522 stuck on standby

This is Not a real Fix, However it stops the problem!
Do not plug any power cords into the Receiver. I have found that using the "switched or unswitched" plugs in the back cause the trouble.

Nov 15, 2007 | Onkyo TX-8522 Receiver