Will not stop filling - Toto Orinigal Replacement Part Thu013p 1 piece dual valve assembly

use the features fuzzy logic, u only need to power on and start on the machine when u hve fill in the tub with cloths and soap. water will fill in according to the load filled.

Singer 7422 keeps stopping with lights flashing when filling ...

www.fixya.com/support/t26006759-singer_7422_keeps_stopping_lights

4 hours ago - Singer 7422 keeps stopping with lights flashing when filling bobbin Machine stops ... Machine stops and red lights flash when loading bobbink.

What is the model number of your unit?

Does it stop filling if you stop the cycle or do you need to turn the faucet off?

Your fill hose that runs off the drum to the fill control controller on the front panel either has a leek an needs replaced or the controller its self need replacing, the line is cheaper, also look on the drum were the line go to, make show there is no leaks, this is a low presser an vacuum line,

you need to replace the water level switch

To javed_iqb904, does the drum actually fill or does it seem like that water is draining out as it's filling?


To neonllama19, if it fills with the tap on and the machine off, it sounds like a defective water valve. If it never stopped filling it sounds like a defective pressure switch or hose to the pressure switch is loose or diconnected.

You may have a faulty door switch.

If you turn power off to machine (or unplug) and washer continues to fill, you need to replace the water inlet valve. (the part the hoses connect to) If cutting power stops the water fill, you have a problem with the water level switch or the tubing leading to it.

you may have a problem with your pressure switch. or sometimes they call it the water level switch.

try to use it in the small level and see if it would stop filling around medium or large quantities of water.

if it would stop filling , then replace the water level sensor.

tnx 4 using fixya,

drcool