How far down is the wire signal arm supposed to be

Good Afternoon Rsimmon5,

I see that you are trying to turn off the ice maker to your Frigidaire refrigerator, model# FRS6R5EMB. You will be moving the signal arm to turn your refrigerator off.

To begin ice production, lower the wire signal arm to the DOWN or ON position. The ice maker turns off automatically when the ice container becomes full. To stop the ice maker, raise the wire signal arm until it clicks and locks in the UP or OFF position.

If you have any trouble with your ice maker continuing to make ice after this, I recommend contacting either the manufacturer or an authorized technician in your area. Hope this helps.

-Best Regards-
WP

Ice maker wire signal arm is being held down by some item in the freezer. Move item and release wire signal arm. Any ice cubes that are frozen together over the wire signal arm. the ice rises in the ice bucket and pushes the wire signal arm up and this is what stops ice production as ice is used then arm comes down and starts ice production all over again. if there is nothing holding arm down then you will need to replace ice maker.

Probably a flaw with the original design. That's why it didn't last very long. Get the mounting bracket and order the switch online.

Yamaha 2005 150 HPDI wiring diagram

Looking for wiring diagrams for digital tachometer with trim indicators and warning signals. Mine had the plastic trip arm break. No trim reading on Tach face. Replaced trip arm forsensor arm and now have no reading on the tach at all except extremely light tach Number. All other electrical components work OK.

Just a heads up, if you are changing the ignition due to security failure, there are other ways to fix this.
http://vatspasslockpasskeysecurityhelp.yolasite.com/

The little pipes that spray the windshield washer fluid clog very easily. Use either a very thin piece of wire or a very small drill bit (a welder's "tip cleaner" works perfect!) to clean out the sprayers. Use only 100% bottled washer fluid and not tap water since the minerals will clog up the sprayers.

Make sure the rubber hoses between the pump and the sprayers did not pop off or split. If your fluid level goes down but you get no spray it is going somewhere it is not supposed to.

When you activate your windshield washers, you should be able to hear that little pump run- it makes a very distinctive sound. If you do not hear it, there is a wiring problem.

The arm is traveling too far. You may can take the plastic endcover off the ice maker to observe the end of the arm and slightly bend it there so it won't go as far.

check the wires on the back of amp meter.dodges are know for that

There are 2 bolts on the top corners of the bulb lens that needs to be removed then the lens pops right out and you can change the bulb.

The ligth is supposed to flash on and off slowly all the time the car is locked to let you know the system is armed. It's supposed to do that. Small red light on dash.