Question about Frigidaire Ovens

Open Question

Pfef385jhs1 oven timer removal - Frigidaire Ovens

Posted by Anonymous on

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Nothing is working in my oven not even the led timer is lighting up


When the timer, clock etc didn't light up my oven stopped working. Replaced the clock display unit and all is now fine. A simple switch over just remove one wire at a time and place it on the new unit, the only difficult part was gaining access to remove the display unit itself.

Sep 08, 2015 | Ovens

1 Answer

Whirlpool loc


From a google search the following is copied:

LOC is a control panel lock not a door lock, see below.

The Control Lock shuts down the control panel pads to prevent
unintended use of the ovens.
When the control is locked, only the CLOCK, TIMER SET and
TIMER OFF pads will function.
The Control Lock is preset unlocked, but can be locked.
To Lock/Unlock Control: Before locking, make sure the ovens,
Timer and Timed Cooking are off. Press and hold START/ENTER
until a single tone sounds and "Loc," a picture of a lock and
"START?" will appear on the oven display, about 5 seconds.
Repeat to unlock and remove "Loc" from display.

If the above does not work have you tried removing power from the uit for a few minutes to see if it will reset.
________________

http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/499415-whirlpool-double-oven-shows-loc-display.html

Jan 26, 2018 | Ovens

1 Answer

Do I have to pull the whole double oven assembly out of the wall to gain access to the upper oven power relay board? MCS230S


On some ovens you have to pull the oven out of the cavity and remove the top panel of the oven to get access to the electronic timer control. On other ovens you only have to remove the panel which is behind the timer without removing the whole thing. Just slide it out a bit and have a look at the panel behind the timer.

Feb 16, 2011 | Dacor MCS230SS Millennia Electric Double...

1 Answer

Moffat Stove with a self-cleaning oven. I would like to know how to clean the oven using the "self cleaning" feature


hi there! I have a moffat stove and hopefully these instructions help you.
First clear out the racks in your oven. Take them out and remove any excess chunks at the bottom.
Then close your oven door and lock it by pulling the lock latch.
Now looking at your oven knobs [not your burner knobs] turn both of them so they are both on the arrow knob [your oven knobs should have small pictures on them and both should have arrows]
Now you need to set the time so in the middle of your oven their should be a timer and one start and stop timer on top of each other. Both timers go in increments of half an hour. So if you are starting your self cleaner at 3 move the dial to 3 or if you are starting at 3:30 move the dial to one tick after 3. Once you set your start timer, you need to set your stop timer.
Setting your stop timer, it is recommended to set it for 3-5 hours. I set mine for 4 hours. So then set stop timer to time you want the cleaning to be. If you set your start timer at 3:30 put your stop timer at 7:30.
The oven will start cleaning according to the time you set. The oven will get very hot. I recommend to not used the burners as the temperature goes to 500 degrees! You will smell an odor and that is your oven cleaning.... Hope this helps...

Sep 13, 2010 | Ovens

1 Answer

Turn off the timer on an old imperial st george


I have this exact same oven and this "feature" annoys me no end. To turn it off ... turn the clock dial to PAST the time that the timer dial shows. EG: If your timer dial is showing 6, turn the clock dial so that it rolls past 6 o'clock. This will pop out the timer dial and thus turn off the timer, allowing you to use the oven normally.

To stop accidentally pushing/turning that timer dial, I removed the knobs. Good luck.

Jan 23, 2010 | Ovens

1 Answer

Cook timer keeps chiming


it starts chiming every min AFTER the timer counts down the allotted time?? thats normal operation its remonding you that the timer has completed cookin and to remove food from oven.. it will continue cooking with residual heat if not removed

Nov 25, 2008 | Kenmore 40494 / 40495 / 40499 Electric...

2 Answers

Oven not heating to proper temp


go to: RepairClinic.com

you'll need make & model #.

Nov 16, 2008 | Frigidaire Ovens

1 Answer

Dacor cps130 wall oven f1 error


hi The range timer is usually located in the control panel on top of the range. If you suspect the timer is faulty, don't try to fix it yourself. Remove it and take it to a professional service person for testing. Here's how to remove the timer:

Step 1: Remove the back service panel to the control panel and release the spring clips that hold it in position, or remove the retaining screws.

Step 2: Push the timer forward to release it.

Step 3: Remove the electrical lead wires from the timer housing. If, when disassembling the timer, you notice that the electrical wire terminals look burned, remove these leads and buff the leads and the terminal points with fine steel wool. Burned and/or dirty terminals can cause the timer to malfunction, but a good cleaning can solve this problem.

Step 4: Replace the old timer or install a new one of the same size and type, if this is necessary. Connect the new timer the same way the old one was connected.

Nov 06, 2008 | Dacor MCS130 Millennia Electric Single...

1 Answer

Preheat worksoven wont bake


hi The range timer is usually located in the control panel on top of the range. If you suspect the timer is faulty, don't try to fix it yourself. Remove it and take it to a professional service person for testing. Here's how to remove the timer:

Step 1: Remove the back service panel to the control panel and release the spring clips that hold it in position, or remove the retaining screws.

Step 2: Push the timer forward to release it.

Step 3: Remove the electrical lead wires from the timer housing. If, when disassembling the timer, you notice that the electrical wire terminals look burned, remove these leads and buff the leads and the terminal points with fine steel wool. Burned and/or dirty terminals can cause the timer to malfunction, but a good cleaning can solve this problem.

Step 4: Replace the old timer or install a new one of the same size and type, if this is necessary. Connect the new timer the same way the old one was connected.

Nov 06, 2008 | Tappan 30IN ELEC IGNa Oven

3 Answers

De Dietrich Oven - Clock tripping back to 00:00 means I cant turn on my oven!


its a fix more than a solution but you can bypass the clock thus allowing the oven to operate again
unplug at the mains and remove the oven from the housing remove the two fastening screws from the metal lid on the top of the oven ,and remove the lid
you will see the timer back panel with 3 wires coming to it, 2 are black (switching line) and 1 is red (Live feed to timer )
If you pull the connectors from the 2 black wires from the timer board and connect the ends together using a connector block, the timer switch becomes inactive and allows the oven functions to operate again.
you will have no timer functions but its a cheap fix and who uses the timer any way
good luck Andy B
ps if anyone has a set of operating manuals for ths oven i would be glad of a copy

May 13, 2008 | De Dietrich DOC310 Electric Single Oven

Not finding what you are looking for?
Ovens Logo

Related Topics:

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Frigidaire Ovens Experts

Michael Thomas
Michael Thomas

Level 3 Expert

3056 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Kell Le

Level 1 Expert

5 Answers

Are you a Frigidaire Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...