Getting an error on console which repeats fairly regularly. Ideas? See content below event: Carrier check failure from node local:.lurker CSMA-CD station CSMACD-0

Print head failure. All you can do is to remove the cartridges, flip up the securing lever and extract the print head assembly from the carrier then clean its contact and the pins on the carrier. If that doesn't fixes it then either the data ribbon cable that connects the carrier to the board or the processor are damaged. In both cases the repair will cost more than a new printer so it's time for a new one.

Hard drive has bad sectors. Before your replace your hard drive when getting this error, try this- Boot from a Windows XP CD and choose Repair at the first prompt to get the recovery console. Type "chkdsk c: /p/r" at the prompt. Repeat until there are no errors found. Exit and reboot. It worked for me.

There are certain types of WiFi that can't be picked up by the DS Lite which prompts you error 51099. For example, you can't use a security protected WEP WiFi. I encountered this problem with my DS also and if you know how to remove the password on your WiFi router, that should solve the problem, however it leaves your network unsecured so I suggest doing that only to receive the event gift.
Nintendo also has a detailed troubleshoot guide for that error which I've provided a link below.
http://www.nintendo.com/consumer/wfc/en_na/ds/results.jsp?error_code=51099&system=DS&locale=en_US
Cheers and good luck with getting Victini!

You might want to talk to the local radio dealers in your area. A repeater system may already be in place to work with your radios. The radios themselves would need to have a channel programmed to match the repeater. If what you have is an annual event, it would likely be relatively inexpensive or free to use an existing repeater.

Best regards.

Boot to the WIndows XP CD, and at the first prompt, press R to enter Recovery Console. Once at the C: prompt, type CHKDSK /R and let the run, once finished, reboot and see if the system will boot.

If it still is in a reboot loop, or if CHKDSK reports unrecoverable errors, then you may have a hdd problem, run HDD diagnostics and see if you get a failure code.

If diags pass, try repairing the installation with the XP CD (Odds are fair to poor at fixing issue) if that fails try a clean install of XP (Sometimes that is the only resolution)

If the HDD fails diags or if all the above fails, replace the hard drive

When Windows crashes with blue screen, it writes a system event 1001 or 1003 and a minidump to the folder \windows\minidump. Check system event 1001 and 1003 and it has the content of the blue screen

Event ID: 1001
Source: Save Dump
Description:
The computer has rebooted from a bugcheck.The bugcheck was : 0xc000000a (0xe1270188, 0x00000002, 0x00000000, 0x804032100).
Microsoft Windows..... A dump was saved in: .......

Event Source: System Error
Event Category: (102)
Event ID: 1003
Description:
Error code 1000007f, parameter1 0000000d, parameter2 00000000, parameter3 00000000, parameter4 00000000

Control Panel -> Adminstrative Tools -> Event Viewer -> System -> Event 1001/1003. Copy the content and paste it back here

I think, you have a problem whit keyboard, may be Ctrl key is failed or is broken

Those codes are related to an abnormal toner to carrier ratio. If you are getting multiple errors that could be a control board failure. I will consult Konica Minolta Solutions and post futher as the information becomes available.

The problem your describing is dirt under the button.
Any local store has them, home hardware, walmart,zellers,etc.
They run fairly cheap, probally around 5 dollars.
Try getting a hold of a screwdriver, and cleaning the inside of dirt.
PS this would usually happen when you play with dirty fingers.
So my advice, wash up! ;)