Question about ViewSonic VA720 17" LCD Flat Panel Monitor

1 Answer

AC/DC Adapter Can anyone tell me what the dc voltage output of the adapter is? I was givin one of these monitors, but no power adapter. Thanx, Bill

Posted by on

  • FXWGBill Sep 14, 2007

    Excellent! Thank you. I'll see if I can't either procure one, or rig up something with a power supply that I have around.

    Thanx again...

    Bill

×

Ad

1 Answer

Louie Role
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points
    All-Star:

    An expert that got 10 achievements.
    MVP:

    An expert that got 5 achievements.
    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 6,966 Answers

Hi, You would need an adapter that puts out 12 Volt DC, Output Current: 3.3 Amp and the Center Positive Power Tip (Output Power: 40W). The original ViewSonic adapter is M/N: UP06031120A Hope this be of some help/idea/ Post back how things turn up or should you need further information. Good luck and kind regards.

Posted on Sep 13, 2007

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need to know input, polarity and voltage to ensure I have the right adapter.

Complete Guide to Using the Correct Charger or Power ...

www.groovypost.com/.../choose-right-power-adapter-charger-phone-lap...
Jun 24, 2013 - If the device has a DC input of +12V / 5.4A, get an adapter that has a DC output of +12V / 5.4A. If you have a universal adapter, make sure it has the proper current rating ... Ideally, you'll have the same voltage, current and polarity on your ......or hdmi on my laptop .can you say what's the reason for the same.

How to select an AC to DC power adapter - ApogeeKits

www.apogeekits.com/power_adapter_selection.htm
An explanation of regulated versus un-regulated AC to DC voltage power adapters. ...voltage output power adapters and how to use this information to select the right one... Some (more expensive) DC voltage output power adapters have voltage ... Care should be take to ensure that the maximum input voltage of the load ...

AC/DC Power adapter ' Laptop Parts 101

www.laptopparts101.com > Laptop parts
Dec 26, 2008 - It's very important to use the right adapter for your laptop. ... Polarityon the new adapter's plug must be the same as on the original ... AC/DC power adapter voltage and amperage ..... I have purchased an non-hp dc-dc convertor (150W), 12Vinput, 19V output. .... So the cable component has to be replace.

Determining Proper A/C Polarity - Galen Carol Audio

www.gcaudio.com > Resources > How-To's

Jan 10, 2016 | Computers & Internet

1 Answer

What is the power output of ac dc adapter in jensen jta 460? Can this adaptor be changed with 220volt ac dc adapter with required dc output?
For Any Adapter:
As long as the Voltage and Power output of the power supply (wall outlet or other) matches the input requirements for the adapter whether 110V or 220V.at enough amp output; and
IFF the dc output of the adapter is exactly the same voltage and has for amps at a minimum matches the maximum amperage requirement for the input of the device, any of them will work, as long as it has the right connector with the correct polarity needed for the device!

Or, in other words...

Supply Output V = Adapter Input V
and
Adapter Output V = Device V
Adapter Output A(min) >= Device A(max)

Aug 27, 2015 | Computers & Internet

1 Answer

I need an ac power supply 19vdc-3a Adv178B modelEZ17F Where can I find one...Please help.
http://www.google.com/products?q=advueu+power+supply&oe=utf-8&rls=org.mozilla:en-US:official&client=firefox-a&um=1&ie=UTF-8&ei=zJ4hS_mFBMuBnQeetMTxCQ&sa=X&oi=product_result_group&ct=title&resnum=4&ved=0CCAQrQQwAw


Advueu ADV178B LCD Monitor POWER SUPPLY CORD
19V AC power adapter for Advueu Technology EZ18A LCD monitor
Adapter Type: LCD monitor power supply

Input Voltage: 100-240VAC (50-60Hz)

Output Voltage: 19 Volts DC

Amperage: 3.16 Amps
Price: $24.99


Dec 11, 2009 | Advueu Technology ADV178 17" Flat Panel...

2 Answers

Adapter/power supply cord missing emachine model SP 30A speakers
AC/DC Adapter
Model MA-9200
Input 120 VAC 60 Hz
Output 9 VAC 200 Ma
Class 2 Transformer

Oct 17, 2009 | Audio Players & Recorders

2 Answers

Power failure issues
The specs for this monitor is a 60 Watt, 12 Volt, 5 Amp power adapter. The voltage must be the same. You can always get an adapter with a higher Amperage rating, but never get one with less, as this can overheat the adapter and damage it. I was not able to locate specs on whether the voltage to the monitor is DC or AC... most are DC. If this is the case, the observe the polarity at the monitor. Power adapters have a positive and a negative... center and outer contact, Make sure that the power adapter matches that of the monitor, else it will not work.

Sep 26, 2009 | Balance CM2017 17" Monitor

3 Answers

Use Sony ICF-C1IPMK2 in Europe
A transformer type (Linear Mode Power Supply) AC to DC power adapter with a 9.V nominal output, measures about 12.V without load when tested with a multimeter. A power adapter with a nominal output of 7.5 V, measures a little over 9.V. Considering a number of people across different forums reported the adapter's measured power output as 12.V, I think the nominal rating of the AC to DC adapter should be 9.V. However, keep away from Switch Mode Power Supplies.

Jul 21, 2009 | Sony ICF-C1IP White Powered Speaker System...

1 Answer

Monitor does not work I suspect power adapter
hello, the ouput voltage varies, depending on the type of monitor and size. if it is Hp product is 18Volts.but since it is philips i suggest you look at the body of the adapter where you will see the Dc ratings and other Voltage ratings. and you can go along with the adapter to the store you are buying a new one.

Apr 12, 2009 | Computers & Internet

2 Answers

Cpqusbfw usb hub
i have one of those hubs the ac adapter is output +5V, and current 0.2 - 2.5A, inside of connector is pos(+), outside is neg(-), input: 100 - 120 Vac and 0.45A Max

Aug 30, 2008 | Micro Innovations Compaq CPQ24USB

2 Answers

Microsoft Force Feedback 2 joystick - Lost Power Supply.
Hope this helps.
Part No. 96749 (Maybe Ebay?)
Input: 230V~ 50Hz
0.15A
Output: 12V 1.3A

Apr 28, 2008 | Microsoft SideWinder Force Feedback 2...

1 Answer

Daewoo monitor
If you know a little bit about electronics, then you can find or buy a multimeter to check the output voltage of the AC/DC power adapter (if it uses one, sometimes the converter/adapter is inside the monitor). In order to get a voltage reading from center "hole" of the end of the power cord, use a paper clip (thicker paper clip if you have it). If the converter voltage is good, then this monitor might be a warranty return candidate. Hope it's only a power adapter problem (you can find a replacement on Ebay) ZT3000 "Beta tester of "0"s and "1's"

Aug 21, 2007 | Daewoo F227B Monitor

Not finding what you are looking for?

View Most Popular

VA720 17" LCD Flat Panel Monitor

  • Computers & Internet

Related Question

Need to know input, polarity and voltage to ensure I have the right adapter.

  • Computers & Internet

Open Questions:

0 Answers

monitor screen my screen is distored

Mar 16, 2014 | ViewSonic VA720 17" LCD Flat Panel Monitor

0 Answers

how to connect ViewSonic VA270 monitor to macbook

Apr 28, 2012 | ViewSonic VA720 17" LCD Flat Panel Monitor

0 Answers

Green Pixles when TV should be displaying black or dark images My 42" Polaroid LCD Television that I bought in 2008 is displaying green pixles when they should be black. It does this for both the TV connection and when watching movies on the DVD player. Both of these are connected thru separate HDMI cables. It does not do it all the time, sometimes the TV needs to be on for a couple of minutes before it starts. Does anyone have any idea what might be wrong?

Aug 10, 2017 | ViewSonic VA720 17" LCD Flat Panel Monitor

0 Answers

Faulty USB module on inverter board 20" viewsonic monitor...has a small USB module plugged into the inverter board to allow Usb connections to the monitor. I have the same problem on both 20" monitors. The module is faulty...it pulls the 3.3 Volts to ground. Any chance of me getting a replacement? DAL0VPUB012 Rev.A A3C 22l0VPUB005 are the numbers on the module. Thanks for your time and concern. [email protected]

May 09, 2009 | ViewSonic VA720 17" LCD Flat Panel Monitor

Related Topics

ViewSonic VA720 17" LCD Flat Panel Monitor Logo

Related Topics:

491 people viewed this question

Ask a Question

Usually answered in minutes!

Popular Questions

ViewSonic VE710b 17" Flat Panel...

ViewSonic VX924 19" LCD Monitor

ViewSonic VX922 19" Monitor...

ViewSonic VX900 19" LCD Monitor

ViewSonic E70f 17" CRT Monitor

Check Out the Mobile Browsers Report
Check Out the Mobile Browsers Report

View all Fixya Reports

Top ViewSonic Computers & Internet Experts

Ekse

Level 3 Expert

13434 Answers

Cindy Wells

Level 3 Expert

6073 Answers

Dimitar Todorov

Level 2 Expert

240 Answers

Are you a ViewSonic Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

PDF Manual
. VA720 17" LCD Flat Panel Monitor...

VA720 17" LCD Flat...

Loading...